Electrolux EWF 106210 A, Руководство пользователя

Страница: 15 / 20

Problem Possible cause Possible solution
The connection of the water
drain hose is not correct. Make sure that the connection is cor-
rect.
A washing programme without
the drain phase is set. Set the drain programme.
The function Rinse Hold is on. Set the drain programme.
The spin phase does
not operate. The spin phase is off. Set the spin programme.
The filter of the drain pump is
blocked. Clean the filter of the drain pump. Refer
to 'Care and cleaning'.
Balance problems with the
laundry load. Adjust manually the items in the tub and
start the spin phase again.
There is water on the
floor. Leakages from the couplings
of the water hoses. Make sure that the couplings are tight.
Leakages from the drain
pump. Make sure that the drain pump filter is
tight.
The water drain hose is dam-
aged. Make sure that the water inlet hose has
no damages.
You cannot open the
appliance door. The washing programme is in
operation. Let the washing programme end.
There is water in the drum. Set the drain or the spin programme.
The appliance makes
an unusual noise. Incorrect level of the appli-
ance. Adjust the level of the appliance. Refer
to 'Installation'.
You did not remove the pack-
aging and/or the transit bolts. Remove the packaging and/or the trans-
it bolts. Refer to 'Installation'.
The load is very small. Add more laundry in the drum.
The appliance fills with
water and drain imme-
diately. The end of the drain hose is
too low. Make sure that the drain hose is in the
correct position. Refer to 'Installation'.
The washing results
are not satisfactory. The detergent you used was
not sufficient or correct. Increase the detergent quantity or use a
different one.
You did not remove the stub-
born stains before you wash
the laundry. Use special products to remove the
stubborn stains.
Incorrect temperature was set. Make sure that you set the correct tem-
perature.
Too much laundry load. Decrease the laundry load.
After the check, activate the appliance. The programme continues from the point of inter-
ruption.
If the problem occurs again, contact the service centre.
Service
Refer to the information supplied with this
appliance for guarantee condition and point
of contact. The information to give to the
service is on the rating plate.
We recommend that you write the
information here:
Model ..................
Product number 914.............
Serial number
(S.N.) ..................
electrolux 15