Electrolux EWD 1477, Инструкция пользователя

Страница: 28 / 32

28
Something not working?
Problem Possible cause
• The machine does not start up: • The door is not firmly closed. (E40)
• The machine is not plugged in or there is no power
at the socket.
• The main fuse has blown.
• The type of fabric has not been selected by means of
the relevant selector dial.
• The Start/Pause button has not been depressed.
• The Delay Start option has been selected.
• The machine does not fill: • The water tap is closed. (E10)
• The inlet hose is squashed or kinked. (E10)
• The filter in the inlet hose is blocked. (E10)
• The door is not properly closed. (E40)
• The machine fills then empties
immediately:
• The end of the drain hose is too low. Refer to
relevant paragraph in “water drainage” section.
• The machine does not empty
and/or does not spin:
• The drain hose is squashed or kinked. (E20)
• The option RINSE HOLD has been selected.
• The drain pump is clogged. (E20)
• There is water on the floor: • Too much detergent or unsuitable detergent
(creates too much foam) has been used.
• Check whether there are any leaks from one of the
inlet hose fittings. It is not always easy to see this
as the water runs down the hose; check to see if it
is damp.
• The drain hose is damaged.
• The cap on the emergency emptying hose has not
been replaced after cleaning the pump.
• Unsatisfactory washing results: • Too little detergent or unsuitable detergent has
been used.
• Stubborn stains have not been treated prior to
washing.
• The correct temperature was not selected.
• Excessive laundry load.
• The machine vibrates or is
noisy:
• The transit bolts and packing have not been
removed.
• The support feet have not been adjusted.
• The laundry is not evenly distributed in the drum.
• Maybe there is very little laundry in the drum.
Problems which you can resolve yourself.
During machine operation it is possible that one of the following alarm codes appears on the display and an
acoustic sound can be heard:
-
E10 : problem with the water supply
- E20 : problem with water draining
- E40 : door open
Once the problem has been eliminated, press the Start/Pause button to restart the programme. If after all
checks, the problem persists, contact your local Service Centre.
Please be aware that any service calls which could have been solved by following the instructions (e.g.
removing transit devices, removing blockage from drain pump, adjusting levelling feet, tightening inlet hose
etc.) will be payable by the customer.
132973270_correct.qxd 29/03/2007 10.12 Pagina 28