background image

Daily use

Loading washing

• Open the lid of the

appliance.

• Open the drum by

depressing the
locking button A:
The two shutters
unlock automati-
cally.

• Load the washing,

close the drum and
the lid of your
washing machine.

Warning!

  Before closing the lid of your

appliance, ensure that the drum is properly

closed :
• When the two shutters are closed,
• locking button A released.

Proportioning of detergents

Pour the amount of washing powder into the
washing 

 and prewash 

 compartments if you

have selected the “prewash” option. Pour fabric
softener into the compartment   if necessary.

Selection of desired programme

Turn the programme selector to the required pro-
gramme. The “Start/Pause” pushbutton flashes
green.
If you turn the programme selector to another pro-
gramme while a cycle is in progress, the appliance
will ignore the new selected programme. The
“Start/Pause” pushbutton flashes red for a few
seconds.

Selecting the spin speed

Press the “Spin” 

 pushbutton to change the spin

speed.
The maximum spin speed is 700 rpm
(EWB75100W) or 600 rpm (EWB65100W).
At the end of the programme, if you have selected
“Rinse hold” 

 , you then need to select a “Spin”

 or “Drain” 

 programme to finish the cycle and

empty the water.

Selecting options

You must select the different options after select-
ing the programme and before pressing the “Start/
Pause” pushbutton (see “Programmes table”).
Press the desired button(s) : the corresponding
lights come on. If pressed again, the lights go out.
If one of the options is not compatible with the se-
lected programme, the “Start/Pause” pushbutton
flashes red.

“Prewash” option

The appliance runs a prewash at 30°C max.

A

“Daily” option

This option allows to run a wash cycle of lightly
soiled laundry at reduced time.

“Super quick” option

The washing time will be reduced depending on
the programme selected.

“Rinse plus” option 

The washing machine will add one or more rinses
during the cycle. This option is recommended for
people with sensitive skin and in soft water areas.
Temporary : Press the “Rinse plus” 

 pushbut-

ton. The option is only active for the selected pro-
gramme.
Permanent : Hold down the “Spin” 

 and “Op-

tion” pushbuttons for a few seconds. The option is
permanently activated, even if the appliance is
switched off. To deactivate it, repeat the process.

“Delay start” 

This option allows you to delay the start of a wash
programme by 3, 6 or 9 hours by pressing the
“Delay start” pushbutton 

 .

You can change or cancel the delayed start time
at any time before you press the “Start/Pause”
pushbutton by pressing the “Delay start” pushbut-
ton 

 again (when all indicators are off, the wash

programme will start immediately).
If you have already pressed the “Start/Pause”
pushbutton and you want to change or cancel the
delayed start, proceed as follows :
• To cancel the delay start and start the cycle im-

mediately, press “Start/Pause” and then “Delay
start” 

 . Press “Start/Pause” to start the cycle.

• To change the timer delay period, you must go

through the “Stop” position 

 and reprog-

ramme your cycle.

The lid will be locked during the delayed start time.
If you need to open it, you must first pause the ap-
pliance by pressing the “Start/Pause” pushbutton.
After closing the lid again, press the “Start/Pause”
pushbutton.

Start of the programme

Press the “Start/Pause” pushbutton to start the
cycle. The corresponding light will come on green.
It is normal for the programme selector to remain
stationary during the cycle. The light correspond-
ing to the current cycle is illuminated.

 + 

 : P Wash

 +   : Spin

 : End of cycle

Interrupting a programme
Adding washing during the first 10 minutes

Press the “Start/Pause” pushbutton : the corre-
sponding light will flash green while the appliance

 electrolux

Содержание EWB 65110 W













Отзывы: