Electrolux EW6S3726BL, Руководство пользователя

Страница: 8 / 40

3.3 The inlet hose
WARNING!
Make sure there is no
damage to hoses and there
are no leaks from the
couplings. Do not use an
extension hose if the inlet
hose is too short. Contact
the service centre for a
replacement inlet hose.
1. Connect the water inlet hose to the
back of the appliance.
20º 20º
45º 45º
2. Position it toward left or right
depending on the position of the
water tap. Make sure that the inlet
hose is not in vertical position.
3. If necessary, loosen the ring nut to
set it in the correct position.
4. Connect the water inlet hose to the
cold water tap with 3/4'' thread.
3.4 Water drainage
The drain hose should stay at a height of
no less than 600 mm and not more than
1000 mm.
You can extend the drain
hose to maximum 4000 mm.
Contact the authorised
service centre for the other
drain hose and the
extension.
It is possible to connect the drain hose in
different ways:
1. Make a U shape with the drain hose
and put it around the plastic hose
guide.
2. On the edge of a sink - Fasten the
guide to the water tap or to the wall.
Make sure that the
plastic guide cannot
move when the
appliance drains and the
drain hose end is not
immersed in the water.
There may be a return of
dirty water into the
appliance.
3. If the end of the drain hose looks like
this (see the picture), you can push it
directly into the stand pipe.
4. To a stand pipe with vent-hole -
Insert the drain hose directly into a
www.electrolux.com 8