ENGLISH
5
Installation
Unpacking
You are advised to keep all transit devices so that
they can be refitted if the machine ever has to be
transported again.
1. Using a spanner, unscrew and remove the rear
right-hand bolt and lay the machine on its back,
taking care not to squash the hoses. This can be
avoided by placing one of the corner packing
pieces between the machine and the floor.
2. Remove the polystyrene blocks from the
underside of the machine and release the two
plastic bags.
3. Carefully remove the right-hand bag (1) then the
left-hand bag (2) by pulling them towards the
centre of the machine.
4. Unscrew and remove the feet.
5. Fit the grid (A) on the bottom of the machine using
the four screws (B) you will find in the bag
containing the instruction booklet.
Re-fit the feet.
A
B
P1067
B
B
B
2 1
P1066
P1065S
P0255
All transit bolts and packing must be
removed before using the appliance.
6. Set the machine upright and remove the two
remaining bolts from the back.
7. Pull out the three plastic spacers from the holes
into which the bolts were fitted.
8. Plug the open holes with the plugs which you will
find in the envelope containing the instruction
booklet.
P
ositioning
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is
not impeded by carpets, rugs etc. Check that the
machine does not touch the wall or other kitchen
units.
Carefully level by screwing the adjustable feet in or
out. Never place cardboard, wood or similar materials
under the machine to compensate for any
unevenness in the floor.
Water inlet
Connect the water inlet hose supplied with the
machine to a tap with a 3/4" thread.
Do not use already employed inlet hoses.
The other end of the inlet hose which connects to the
machine can be turned in any direction. Simply
loosen the fitting, rotate the hose and retighten the
fitting, making sure there are no water leaks.
P1088
P1051
P0020
P0256
132995750 EW859F gb.qxd 4/3/02 3:49 PM Pagina 5 (Nero/Process Black pellicola)
Содержание EW 859 F
Страница 1: ......