Electrolux EU8297CX, Инструкция пользователя

Страница: 13 / 15

13
Electrolux 818 15 86-01/0
Installing the cabinet
To otain the best performance from the cabinet, ensure
:
·
the cabinet is placed in a dry, cool place and
is not exposed to direct sunlight.
·
the cabinet is not placed close to a source of
heat, e.g. a cooker or dishwasher.
·
the room in which the cabinet is placed
has a temperature of +16

C to +32

C.
·
the cabinet is level.The cabinet should not lean
against any wall. If necessary adjust the
feet using the supplied adjustment spanner.
·
there is good air circulation around the cabinet
and that the air channels below and behind
the cabinet are not blocked. The ventilation
space above the cabinet and any
grocery/top cabinet must be at least 200 cm
@
.
The ventilation space can either be
a) directly above the cabinet, or
b) behind and above the top cabinet. In this case,
the space behind the cabinet must be at least
50 mm deep.
If the cabinet is placed in a corner and the side with
the hinges faces the wall, the distance between the
wall and the cabinet must be at least 10 mm to allow
the door to open enough so that the baskets can be
removed.
50mm
a)
b)
Electrical connection
This appliance must be earthed.
If the plug that is fitted to your appliance is not
suitable for your socket outlett, it must be cut of and
the appropriate plug fitted.
Remove the fuse from the cut off plug.The cut off
plug should then be disposed of to prevent the
hazard of socket inanother part of your home.
The wires in the mains lead are coloured in
accordance with the following code:
Green and yellow -Earth
Blue -Neutral
Brown -Live
If you fit your own plug, the colours of the Wires in
the mains lead of your appliance may not
correspond with the markings identifying the
terminals in your plug, proceed as follows:
Connect the Green and Yellow (earth) wire to the
terminal in the plug which is marked with the letter
”E” or the earth symbol or coloured greeen and
yellow.
Connnect the blue (neutral) wire to the terminal in
the plug which is marked with the letter ”N” or
coloured black
Connect the brown (live) wire to the terminal in the
plug which is marked with the letter ”L” or coloured
red.
The plug moulded onto the lead incorporates a fuse.
For replacement, use a 13amp BSI362 fuse. Onely
ASTAor BSI approved fuses should be used.
The plug must not be used if the fuse cover/carrier is
lost. The cover/carrier is indicated by the coloured
insert at the base of the plug.
A replacement cover/carrier must be obtained from
your local Service Force Centre.