This dishwasher is designed to be fitted either under a kitchen
counter or a worksurface.
It is essential that the recess dimensions indicated in the
illustration are followed.
No further openings for venting of the dishwasher are required,
but only to let the water fill and drain hose and power supply
cable pass through.
The height of the recess where the dishwasher is to be
installed can vary between 820 and 880 mm from the floor
since the dishwasher is fitted with adjustable feet (max. 60
mm).
Leave a space of 2 mm between the top of the dishwasher and
the underside of the kitchen counter.
Adjusting the height of the dishwasher
To adjust the height proceed as follows:
1. Loosen or tighten the two front feet.
2. Loosen and remove the adjustable plinth.
3. Adjust the rear foot by turning the screw in the middle of the
front kick plate to the left or to the right.
Good levelling is essential for correct closure and sealing of
the door. When the appliance is correctly levelled, the door will
not catch on the levelling spacers on either side of the cabinet.
If the door does not close properly, loosen or tighten the
adjustable feet until the machine is perfectly level.
Adjusting the height of the plinth
It is important for the dishwasher to be absolutely horizontal so
that the door seals properly.
The adjustable feet are to be turned to the left or right until the
dishwasher is horizontal.
If there is a space at the
bottom of the machine,this
can be covered by lowering
the plinth.
Fitting the vapour protection
Fit the adhesive protection
foil onto the front part of the
worktop, along the entire
width.
Fixing to the adjacent units
Secure the dishwasher by screwing it firmly in position under
the bench or to the cupboard beside it. Use the angular
brackets supplied which are fitted into the slots on the top of
the dishwasher (see fig.).
Tighten the machine in position (upwards or sideways) by
using the screws supplied (3.5 x 16 mm).
Tighten the screws so that the dishwasher cannot tip forward
and cause damage when the door is open and loaded.
The dishwasher must be secured to the underside
of the worktop or to adjacent units by using the
brackets supplied.
Neglect to do this can cause injury or damage.
Under no circumstances may holes be drilled
through the sides of the dishwasher since this
could damage the hydraulic components.
Building-in
18
600 mm
II21
II54
