27
Connecting the Dishwasher
Water connection
The dishwasher is fitted with safety devices that pre-
vent the return of wash water into the drinking water
system and comply with the applicable plumbing reg-
ulations.
•
The dishwasher can be connected to cold and hot
water supplies up to max. 60 °C.
•
The dishwasher
must not
be connected to open
hot water appliances or instantaneous water heat-
ers.
Permitted water pressure
Connect the inlet hose
1
The water inlet hose must not be kinked,
crushed or entangled when it is being con-
nected up.
Connect the threaded hose fitting (DIN 259)
on the water inlet hose to a tap with an exter-
nal thread (¾ inch). Tighten the threaded
hose fitting
only by hand
.
3
In order that access to the tap in the kitchen
is not limited by the use of the dishwasher,
we recommend the installation of an addi-
tional tap, or the fitting a two way adapter to
the existing tap.
•
If you need a longer water inlet hose than that
supplied, the following VDE approved complete
hose sets are to be used, these are available from
your dealer:
– Hose set "WRflex 100" (E No.: 911 239 034)
– Hose set "WRflex 200" (E No.: 911 239 035)
Lowest permitted water pressure:
1 bar (=10N/cm2 =100 kPa)
For a water pressure of less than 1 bar please seek advice from cus-
tomer service.
Highest permitted water pressure:
10 bar (=100 N/cm2 =1 MPa)
In the case of a water pressure greater than 10 bar, a pressure reduc-
tion valve must be used (available from your dealer).
