Electrolux ESF 6260, Инструкция пользователя

Страница: 10 / 40

10
Adjusting the Water Softener
To prevent the build up of scale on dishes and in the
dishwasher, the dishes must be washed with soft, i.e.
low lime content water. For this reason the dish-
washer is fitted with a water softener in which tap
water from a hardness of 4 °d (German degree) is
softened with the aid of special salt.
3
Your local water authority can advise you on
the hardness of the water in your area.
Adjust the water softener as stated in the table to the
setting that corresponds to the hardness of the water
in your area. The water softener can be set manually
using the water hardness switch and also electroni-
cally using the buttons on the control panel
.
Adjust the water softener to the hardness of the water
in your area as stated in the table:
1. The dishwasher must be switched off.
2. Manual adjustment:
Open the dishwasher door.
3. Remove the lower rack from the dishwasher.
4. Turn the water hardness switch to 0 or 1.
5. Re-position the lower rack.
6. Electronic adjustment:
Simultaneously press and hold down function but-
tons
1 and 2 .
7. Press the ON/OFF button.
The LED displays for the engaged function but-
tons will flash.
8. Press function button 2 again.
The multi-display will show which hardness setting
has been set.
9. Pressing function button 2 increases the hardness
setting by 1.
(Exception: hardness setting 0 follows hardness
setting 9).
10. Once the hardness setting is set correctly, press
the ON/OFF switch.
The hardness setting is then saved.
Water Hardness Hardness Setting
Display in the
Multi-display
in °d
1
) in ppm
2
) Range
Manual Electronic
51 - 70
43 - 50
37 - 42
29 - 36
23 - 28 9,0 - 12,5
7,6 - 8,9
6,5 - 7,5
5,1 - 6,4
4,0 - 5,0
IV 1
9
8
7
6
5 H 9
H 8
H 7
H 6
H 5
0*
19 - 22
15 - 18 3,3 - 3,9
2,6 - 3,2
III
4
3*
H 4
H 3
11 - 14 1,9 - 2,5 II 2 H 2
4 - 10 0,7 - 1,8 I/II 1 H 1
under 4 under 0,7 I
0
no salt
necessary
H 0
1)(°d) German degrees, a measure of water hardness
2)(ppm), Parts Per Million
*factory setting