Electrolux ERF3716AOW, Руководство пользователя

Страница: 11 / 20

Problem Possible cause Solution
Temperature is set incor-
rectly.
Refer to "Operation" chapter.
Water flows on the rear
plate of the refrigerator.
During the automatic de-
frosting process, frost
melts on the rear plate.
This is correct.
Water flows inside the re-
frigerator.
The water outlet is clog-
ged.
Clean the water outlet.
Food products prevent
that water flows into the
water collector.
Make sure that food products
do not touch the rear plate.
Water flows on the floor. The melting water outlet is
not connected to the
evaporative tray above the
compressor.
Attach the melting water out-
let to the evaporative tray.
The temperature in the ap-
pliance is too low/too high.
The temperature regulator
is not set correctly.
Set a higher/lower tempera-
ture.
The door is not closed
correctly.
Refer to "Closing the door".
Food products placed in
the appliance were too
warm.
Allow food products to cool
to room temperature before
storing.
Many food products were
put in at the same time.
Wait some hours and then
check the temperature again.
The door has been
opened often.
Open the door only if neces-
sary.
There is no cold air circu-
lation in the appliance.
Make sure that there is cold
air circulation in the appli-
ance.
If the advice does not lead to
the desired result, call the
nearest brand-mark service.
7.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
the assembly instructions.
3. If necessary, replace the defective
door gaskets. Contact the After Sales
Service.
7.3 Replacing the lamp
1. Disconnect the appliance from the
power socket.
2. Fold the lamp cover backward by
loosen the front edge.
3. Replace the bulb with one of the same
power and specifically designed for
household appliances (the maximum
power is shown on the light unit) and
with E14 socket type.
4. Reconnect the appliance.
ENGLISH 11