Electrolux ERD176C, Руководство пользователя

Страница: 9 / 16

Problem Possible cause Solution
The temperature in the
appliance is too high. The temperature regulator is not
set correctly. Set a lower temperature.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too
high. Let the product temperature de-
crease to room temperature be-
fore storage.
Many products are stored at the
same time. Store less products at the same
time.
The temperature in the re-
frigerator is too high. There is no cold air circulation in
the appliance. Make sure that there is cold air cir-
culation in the appliance.
The temperature in the
freezer is too high. Products are too near to each
other. Store products so that there is
cold air circulation.
There is too much frost. Food is not wrapped correctly. Wrap the food correctly.
The door is not closed correctly. Refer to "Closing the door".
The temperature regulator is not
set correctly. Set a higher temperature.
Replacing the lamp
1. Disconnect the mains plug from the
mains socket.
2. Remove the screw from the lamp cover.
3. Remove the lamp cover (refer to the illus-
tration).
4. Replace the used lamp with a new lamp
of the same power and specifically de-
signed for household appliances. (the
maximum power is shown on the lamp
cover).
5. Install the lamp cover.
6. Tighten the screw to the lamp cover.
7. Connect the mains plug to the mains
socket.
8. Open the door. Make sure that the lamp
comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
electrolux 9