3
CONTENTS
Warnings
2
Operation
4
Control panel
4
Cleaning the interior
4
Starting up
4
Warning light
4
Electronic thermometer
4
Appliance interior
5
Refrigerator compartment
6
Drink dispenser
6
Superchill compartment
7
Freezer compartment
7
Useful hints for freezing
8
Storing frozen foods
8
Thawing food
8
Ice cube maker
8
Maintenance
9
Cleaning the inside
9
Defrosting
9
Periods of no operation
10
Replacing the bulbs
10
Troubleshooting
11
Technical information
11
Installation
12
Location
12
Electrical connection
12
Positioning
13
Height adjustment
13
Fitting the side panels
13
Fitting the door panels
14
Building the appliance in
16
Fitting the plinth
16
¥ Do not place carbonated or fizzy drinks in the
freezer as it creates pressure on the container,
which may cause it to explode, resulting in
damage to the appliance. Do not use a
mechanical device or any artificial means to
speed up the thawing process other than those
recommended by the manufacturer. Never use
metal objects for cleaning your appliance as it
may get damaged.
Installation
¥ During normal operation, the condenser and
compressor at the back of the appliance heat up
considerably. For safety reasons, minimum
ventilation must be as shown in the relevant
Figure.
Attention: keep ventilation openings clear of
obstruction.
¥ Care must be taken to ensure that the appliance
does not stand on the electrical supply cable.
Important:
if the supply cord is damaged, it must
be replaced by a special cord or assembly
available from the manufacturer or its service
agent.
¥ There are working parts in this product which
heat up. Always ensure that there is adequate
ventilation as a failure to do this will result in
component failure and possible food loss. See
installation instructions.
¥ Parts which heat up should not be exposed.
Wherever possible the back of the product should
be against a wall.
¥ If the appliance has been transported horizontally,
it is possible that the oil contained in the
compressor flows in the refrigerant circuit. It is
advisable to wait at least two hours before
connecting the appliance to allow the oil to flow
back in the compressor.
Environment Protection
This appliance does not contain gasses which
could damage the ozone layer, in either its
refrigerant circuit or insulation materials. The
appliance shall not be discarded together with
the urban refuse and rubbish. Avoid damaging
the cooling unit, especially at the rear near the
heat exchanger. Information on your local
disposal sites may be obtained from municipal
authorities. The materials used on this appliance
marked by the symbol
are recicable.
2222 220-07
