TECHNICAL SPECIFICATIONS
Electrical connection
Before plugging in, ensure that the voltage
and frequency shown on the serial number
plate correspond to your domestic power
supply. Voltage can vary by ±6% of the rated
voltage. For operation with different voltages,
a suitably sized auto-transformer must be
used.
The technical data is indicated in the rating plate on the left side inside the appliance.
GB
Fig. 3
Fig. 4
4
Rear spacers
In the bag with the documentation, there are
two spacers which must be fitted into the
special openings provided on the back of
the appliance.
Push-fit the spacers into the openings, making
sure that arrow (A) is positioned as per Fig. 2
and then turn the spacers through 45° until they
lock in (arrow in vertical position).
with lukewarm water and some neutral soap so
as to remove the typical smell of a brand-new
product, then dry thoroughly. Do not use
detergents or abrasive powders, as these will
D039
A
45
°
Fig. 2
Door reversibility
Unplug the appliance before carrying out
any operation.
Remove the upper hinge (Fig. 3) and slide the
top door off the middle hinge.
Remove the middle hinge, turn it through 180°
and refit it on the opposite side (Fig. 4) after
having removed the plugs which mask the
holes. The plugs must be refitted in the holes
left open on the opposite side.
Refit the top door and the top hinge. Unscrew
the lefthand levelling foot, which will be refitted
on the opposite side. Unscrew the right-hand
levelling foot, the corresponding hinge and the
stop and refit all these on the left-hand side
(Fig. 5).
Reverse the handles.
Attention
After completion of the door reversibility
operation, verify that the door gasket is
adherent to the cabine”. If the ambient
temperature is cold (i.e. in Winter), the gasket
may not fit perfectly to the cabine”. In that case,
wait for the natural ftting of the gasket or
accelerate this process by heating up the part
involved with a normal hairdrier.
D053
D185
PR132
Fig. 5
Fig. 6
