11
INSTALLATION
If this appliance featuring magnetic door seals is
to replace an older appliance having a spring lock
on the door or lid, be sure to make that spring lock
unusable before you discard the old appliance.
This will prevent it from becoming a death-trap for
a child.
Location
Place the appliance as far away as possible from
sources of heat, e.g. radiators, heaters, direct sun-
light, etc. The best results are achieved with a room
temperature ranging from +18
°
C to +43
°
C (class T) or
from +18
°
C to +38
°
C (class ST). The class of your ap-
pliance is shown on its rating plate.
Make sure that there is nothing at the back, at the top
and at the bottom of the appliance to obstruct air cir-
culation.
For a more efficient operation of the appliance the
minimum distance between the top of the appliance
and other overhanging kitchen furniture, if any, should
be at least 100 mm (Fig. 1-A).
The best solution is shown in Fig. 1-B (without over-
hanging kitchen furniture).
One or more adjustable feet mounted on the base of
the appliance make it possible to set it perfectly level.
Fig. 1
Rear spacers
In the plastic envelope containing the Operation In-
structions are also included two wall spacers to be fit-
ted into the special openings provided on the back of
the appliance.
Push-fit the spacers into the openings, making sure
that arrow (A) is positioned as per Fig. 2 and then turn
the spacers through 45
°
until they lock in (arrow in
vertical position).
D042
100 mm min.
A
B
Fig. 2
Power connection
Before plugging the appliance into the mains socket,
check that the voltage and frequency indicated on the
appliance’s rating plate are the same as those provid-
ed by your home power supply.
A 6% fluctuation above or below rated voltage is ac-
ceptable.
For operation using different voltages you should use
an autotransformer of suitable capacity.
The appliance’s plug and the wall socket are fully
compatible, without any need to use adaptors, multi-
ple plugs, etc. If this is not the case, the wall socket
should be replaced to make it compatible.
The appliance MUST be connected to an efficient
earth or ground tap.
The supply lead plug in fact incorporates a special
earth or ground contact for this purpose. If by any
chance the sockets of your domestic wiring system
are not earthed, the appliance must be connected to a
separate earth or ground wire by a qualified electri-
cian, in accordance with existing safety regulations.
The manufacturer declines to accept any liability if
this accident-prevention procedure is not followed.
This appliance complies with E.E.C. directive no. 87/
308 of 2.6.87 relative to radio interference suppression.
This appliance complies with the following
E.E.C. Directives:
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic Compatibil-
ity Directive) and subsequent modifications.
Cleaning the appliance’s interior
Before using the appliance for the first time, wash all
internal parts with lukewarm water and neutral soap
so as to remove the typical «new» smell and then drv
thoroughly.
Do not use detergents or abrasive powders as these
will damage the finish.
D039
A
45°