Electrolux EPWC1MEUKG, Инструкция по эксплуатации, Страница: 6 / 16

6
IMPORTANT
Make sure that the water supply is closed
in order to prevent leakage.
Press the
cover
Open the
cover
Figure 4 Figure 5
Figure 6
ATTENTION
If the inlet pressure of the mains water is
low during the removal of water from the
product, interruptions in the water supply
-
locate the product (to a place of higher wa-
ter pressure) or install a water pressurizer.
Figure 1
IMPORTANT
Make sure there is no leakage in the hose
connections.
To prevent leakage, use sealing tape on
the connections when necessary.
3. Push the tab of the water connection and
remove the protection from the water inlet
(Figure 2).
water inlet protection
Figure 2
Figure 3
4. Fit the water inlet hose into the connection
and push it all the way to the end (Figure 3).
Filter Installation
1. Press the appliance cover to open it. (Figure
4)
2. Open the appliance cover. (Figure 5)
3.
4.
to the product and screw in the direction indi-
cated until it is aligned with the arrow to lock
it (Figure 6).
5. Open the water supply so that the product
6. Press and hold the “RESET FILTER” button
for 3 seconds.
1.Remove the nut from the Metal Adapter with
Valve and insert the PE Tubing through the
nut. Slide the PE Tubing onto the protruding
part of the Adapter where the nut was located
until it reaches the threading.
2.Screw the nut tightly into place to keep the
PE Tubing securely connected to the Metal
Adapter with Valve. Make sure the Valve is in
the o ff position (perpendicular to the PE
Tubing).
PE Tubing PE Tubing
RESET FILTER