16
Operation stop
In order to set an operation stop, the mode
button has to be pressed repeatedly until the
LED
is flashing. Then the desired operation
stop (time frame between time-of-day + 1 minute
and time-of-day minus 1 minute) can be set
using the plus and minus buttons. Once
adjusted it will be stored after approx. 5
seconds, and the LED
remains illuminated
steadily. The display reverts to the time-of-day.
As soon as the operation stop has been
reached, the relay opens and the alarm signal
sounds (4 beeps) and the LED
is flashing.
Pressing any of the buttons stops the signal and
the flashing, the LED goes dark and the relay
closes again.
Using the Hob
The Hob Burners
The symbol on the knob corresponds to a symbol
on the control panel (See description of
appliance).
Off
Maximum level
Minimum level
Use the maximum level for boiling and the
minimum for simmering.
Always choose positions between the minimum
and maximum, never between maximum and off.
Ignition of the burners
•
Push the knob and turn it left to the symbol “big
flame”.
•
At the same time the sparker generator begin
to produce a spark.
•
Release the knob after 10 seconds and watch
that the burner has ignited (until the safety
valve automatically keeps the burner lit).
•
Upon ignition, adjust the flame as required.
OR Power Cut
•
Push the corresponding knob in completely
and turn it left to the symbol “big flame” and
ignite with a match.
•
Release the knob after 10 seconds and watch
that the burner has ignited (until the safety
valve automatically keeps the burner lit).
•
Upon ignition, adjust the flame as required.
If for any reason the flame should extinguish
turn off the relevant control knob, leave for at
least one minute and then re-ignite.
If after a few attempts the burner does not ignite,
check that the burner ring and its cap are correctly
positioned.
Extinguishing of burners
Turn the knob clockwise to mark « ».
