47
Solutions to Common Problems
importaNt
before calling for service, review this list. it may save you both time and expense. this list
includes common experiences that are not the result of defective workmanship or material
in your cooktop.
oVen contRol beePs and disPlays an “f” eRRoR code
• Electronic control has detected a fault condition. Push
CANCEL pad
to clear the display
and stop the display from beeping. Reprogram the oven. If a fault reoccurs, record the
fault number, push the
CANCEL pad
and contact an authorized servicer.
installation
• Place oven rack in center of oven. Place a level on the oven rack. Contact installing agent
if rack and cabinet cutout flooring are not level.
• Kitchen cabinet misalignment may make range appear to be not level. Be sure cabinets
are square and level. Contact cabinet maker to correct problem.
entiRe RanGe does not oPeRate
• When the range is first plugged in, or when the power supply to the oven has been
interrupted, the display will flash. The range cannot be programmed until the clock is
set.
• Be sure electrical cord is securely connected into the electrical junction box.
• Cord/plug is not installed and/or connected. Cord is not supplied with range. Contact your
dealer, installing agent or authorized servicer.
• Service wiring not complete. Contact your dealer, installing agent or authorized
servicer.
• Power outage. Check house lights to be sure. Call your local electric company.
• Short in cord/plug. Replace cord/plug.
• Controls are not set properly. See instructions to set the controls.
• House fuse has blown or circuit breaker has tripped immediately following installation.
• House fuse may not be fully engaged. Check fuse and screw or engage circuit breaker
securely.
oVen liGht does not WoRk
• Burned-out or loose bulb. Follow the instructions under
Oven Light
to replace or tighten
the bulb.
Содержание EI30ES55JS
Страница 1: ...318 203 842 1001 Rev A Use Care Guide Electric Slide In Range ...
Страница 52: ......