Electrolux EHTA060, Инструкция по установке и эксплуатации

Страница: 11 / 32

11
Summary table of the Personal Protection Equipment (PPE) to be used during the various stages of the machine's
service life. (cont'd.)
Stage Protective
garments
Safety footwear Gloves Glasses Safety helmet
○
PPE AVAILABLE OR TO BE USED IF NECESSARY
—
PPE NOT REQUIRED
1. During these operations, gloves must be cut-resistant. Failure to use the personal protection equipment by operators, specialized personnel or users can
involve exposure to damage to health (depending on the model).
2. During these operations, gloves must be heatproof and suitable for contact with water and the substances used (refer to the safety data sheet of the
substances used for the information regarding the required PPE). Failure to use the personal protection equipment by operators, specialised personnel or
users can involve exposure to chemical risk and cause possible damage to health (depending on the model).
3. During these operations, gloves must be suitable for contact with chemical substances used (refer to the safety data sheet of the substances used for
information regarding the required PPE). Failure to use the personal protection equipment by operators, specialized personnel or users can involve exposure
to chemical risk and cause possible damage to health (depending on the model).
C TECHNICAL DATA
C.1 Main technical characteristics
Model EHTA060
ZHTA060
VHTA060
Supply voltage: 400V 3N~ 400V 3N~
convertible to 220-230V 3~ 220-230V 3~
single-phase version 220-230V 1N~ 220-230V 1N~
Frequency
Hz 50 50
Max. power
kW
12.9
1
12.9
1
Power absorbed as factory setting with water supply at
50
℃ [122 ℉ ]
9.9 9.9
Power absorbed with water supply at 65 ℃ [149 ℉ ] 6.9 6.9
Boiler heating elements
kW 9.0 9.0
Tank heating elements
kW 3.0 3.0
Water supply pressure kPa
[bar]
50 - 700
[0.5 - 7]
50 - 700
[0.5 - 7]
Water supply temperature: ℃
[ ℉ ]
10-65 [50-149] 10-65 [50-149]
Water supply hardness for models without incorporated
continuous water softener
°f/°d/°e
14/8/10 max 14/8/10 max
Electric conductivity of water for models without incorpo-
rated continuous water softener μS/cm <400 <400
Concentration of chlorides in water
ppm
<20 <20
Rinse cycle water consumption l 2 (for wash cycle 1 and
2)
4.5 (for wash cycle 3)
2.3 (for wash cycle 1 and 2)
4.5 (for wash cycle 3)
Boiler capacity l 12 12
Tank capacity l 24 24
Standard cycle time with water supply at 50 ℃
2
sec.
45 (for wash cycle 1)
84 (for wash cycle 2)
320 (for wash cycle 3)
50 (for wash cycle 1)
84 (for wash cycle 2)
320 (for wash cycle 3)
Legal noise level Leq
3
dB[A] LpA:68dB
KpA:1.5dB
LpA:68dB
KpA:1.5dB
Protection rating IP25 IP25
Net weight kg 117 117
Power supply cable H07RN-F H07RN-F
Supply cord diameter (min. - max. value)
mm
18 - 25 18 - 25
Latent heat kWh 0.5 0.5
Sensible heat kWh 2 2
1. If activated by software, coincidence of tank and boiler heating elements.
2. Standard cycle time may vary should the inlet water temperature and/or the boiler heating elements be different from that indicated above.
3. The noise emission values have been obtained according to EN ISO 11204.