23
1
Safety Instructions for
the Installer
•
A device must be provided in the electrical installa-
tion which allows the appliance to be disconnected
from the mains at all poles with a contact opening
width of at least 3 mm.
Suitable isolation devices include line protecting
cut-outs, fuses (screw type fuses are to be re-
moved from the holder), earth leakage trips and
contactors.
•
In respect of fire protection, this appliance corre-
sponds to type Y (EN 60 335-2-6). Only this type of
appliance may be installed with a high cupboard or
wall on one side.
•
Drawers may not be fitted underneath the hob.
•
The installation must guarantee shock protection.
•
The kitchen unit in which the appliance is fitted
must satisfy the stability requirements of
DIN 68930.
•
For protection against moisture, all cut surfaces
are to be sealed with a suitable sealant.
•
On tiled work surfaces, the joints in the area where
the hob sits must be completely filled with grout.
•
On natural, artificial stone, or ceramic tops, the
snap action springs must be bonded in place with
a suitable artificial resin or mixed adhesive.
•
Ensure that the seal is correctly seated in the frame
and that it is seated against the work surface with-
out leaving any gaps. Additional silicon sealant
must not be applied; this will make removal more
difficult when servicing.
•
The hob must be pressed out from below when re-
moved.
•
Clean the work surface in the area of the cut-out.
•
Four sealing tapes which are self-adhesive on one
side are supplied with the appliance. Stick these
on underneath the cooking surface along the outer
edge of the ceramic glass hob top. Do not stretch
them. The ends of the sealing tapes must overlap.
Содержание EHS 6650 P
