Electrolux EHI845BB, Инструкция по установке и эксплуатации

Страница: 8 / 12

15 14 electrolux.com
TROUBLESHOOTING
If you tried the above solutions and cannot repair the
problem, speak to your dealer or the customer service
centre. Give the data from the rating plate and an error
message that comes on. Make sure you operated the appliance correctly. If not the
servicing by a customer service technician or dealer will
not be free of charge, also during the warranty period. The
instructions about the customer service and conditions of
guarantee are in the guarantee booklet.
The sensor fields
become hot. The cookware is too large or you put it
too near to the controls. Put large cookware on the rear cooking zones
if necessary.
There is no signal
when you touch the
panel sensor fields. The signals are deactivated. Activate the signals
(refer to “OffSound control”).
comes on
The automatic switch-off operates. Deactivate the appliance and activate it again.
comes on
The Child Safety Device or the Lock
function operates. Refer to the chapter “Operating instructions”.
comes on
• No cookware on the cooking zone.
• Incorrect cookware.
• The diameter of the bottom of the
cookware is too small for the cooking
zone.
• The cookware do not cover the cross.
Put cookware on the cooking zone.
Use the correct cookware.
Use larger diameter cookware.
Cover the cross fully.
and number
comes on
There is an error in the appliance. Disconnect the appliance from the electrical
supply for some time. Disconnect the fuse
from the electrical system of the house.
Connect it again. If comes on again, speak
to the after sales service.
comes on
There is an error in the appliance,
because either the cookware boils dry
or you’ve used incorrect cookware.
Overheating protection for cooking zone
operates. The automatic switch-off
operates. Deactivate the appliance. Remove the hot
cookware. After approximately 30 seconds,
activate the cooking zone again. If the
cookware was the problem, the error message
goes out of the display, but the residual heat
indicator can stay. Let the cookware become
sufficiently cool and refer to “Cookware for
the induction cooking zone” to see if your
cookware is compatible with the appliance.
Enviorment concerns
The symbol
!
on the product or on its
packaging indicates that this product may
not be treated as household waste. Instead
it should be taken to the appropriate
collection point for the recycling of electrical
and electronic equipment. By ensuring this
product is disposed of correctly, you will
help prevent potential negative
consequences for the environment and
human health, which could otherwise be
caused by inappropriate waste handling of
this product. For more detailed information
about recycling of this product, please
Installation Instructions
&,
Warning! Safety instructions
&,
Warning! This must be read! The laws,
ordinances, directives and standards
in force in the country of use are to be
followed (safety regulations, proper
recycling in accordance with the
regulations, etc.)
Important! Installation may only be carried
out by a qualified electrician.
The minimum distances to other
appliances and units are to be observed.
contact your local council, your household
waste disposal service or the shop where
you purchased the product.
PACKAGING MATERIAL
�
The packaging materials are friendly to
the environment and can be recycled. The
plastic components are identified
by marking: >PE<,>PS<, etc. Discard
the packaging materials as household
waste at the waste disposal facilities in
your municipality.
Anti-shock protection must be provided by
the installation, for example drawers may
on­ly be installed with a protective floor
directly underneath the appliance.
The cut surfaces of the worktop are to be
protected against moisture using a
suitable sealant. The sealant seals the
appliance to the work top with no gap. Do
not use silicon sealant between the
appliance and the work top.
Avoid installing the appliance next to doors
and under windows. Otherwise hot cook-