Electrolux EHH 800 X, Инструкция по эксплуатации и сборке

Страница: 9 / 12

9
INSTALLATION
fig.1 1. Cut out worktop to prescribed measurements (fig.1)
or templates (saw exactly along the scribing) and fasten
the fixing springs in the cutout with the enclosed
screws. Position the springs according to the enclosed
template. The upper part of the ressort is the spacing
stop.
2. The working plate must be clean. Check seal for
perfect fit and overall cover. Lower the ceramic hob into
the cut-out. Press firmly on one side then on the
opposite side to snap-in the unit (fig.2) .
A sealing is glued onto the frame so there is no need for
further sealing material (important for the removal in
case of a defect).
The installation of the corresponding control box or oven
will be carried out according to separate instuctions. In
order to protect the appliance from damage only ovens
or control boxes which are approved by the manufacturer
must be connected to the ceramic hob.
The installation of electrical appliances must be
undertaken by qualified electricians only.
Improper repairs can cause serious harm and
danger for users. The protection against
accidental contact must be ensured by proper
installation.
Attention: If installed in stone, ceramic tiles or lava
worktops (fig.3) , the fixing ressorts will not be fastened.
Instead, silicone will be put under the cover frame. To
avoid that silicone runs down between the glass ceramic
hob and the worktop (fig.4 - pos.1) a sealing will be
glued to the ceramic hob (fig.4 - pos.2) . The sealing
can be ordered free of charge under article no. 374 0161-
02.
The distance between the underside of the hob and the
furniture beneath must be at least 60 mm (fig.5) .
Attention:
• If there are any repairs to be effected, the appliance
must be non-tensioned.
• If any fissures or cracks appear on the hob's surface
the hob has to be switched off immediately .
Disconnect the appliance from the mains and inform the
service department.
In terms of fire protection, the appliance conforms
to Type Y (IEC 335-2-6). Only appliances of this
type may be installed on one side of adjacent
upright furniture housings or walls.
Important for the removal of the hob
1. Disconnect the appliance from the mains.
2. In order to take out the whole glassceramic hob, use
a medium flat screwdriver or spatula. Put it in between
the frame and worktop on the area where the snap-
in ressorts are located.
3. Then slightly lift the unit out. Take care not to damage
the worktop.
fig.5
fig.4
pos.1
pos.2
43 mm
min. 30 mm
fig.2
fig.3
43 mm
min. 30 mm