Electrolux EHG 6762, Инструкция пользователя

Страница: 8 / 32

8 electrolux
INSTALLATION
Any gas installation must be carried out by a registered Any gas installation must be carried out by a registered Any gas installation must be carried out by a registered Any gas installation must be carried out by a registered Any gas installation must be carried out by a registered
competent person, and in accordance with existing rules and
competent person, and in accordance with existing rules and competent person, and in accordance with existing rules and competent person, and in accordance with existing rules and competent person, and in accordance with existing rules and
regulations.
regulations. regulations. regulations. regulations.
The relevant instructions are to be found in the second section of this
manual.
Please, ensure that, once the hob is installed, it is easily accessible for
the engineer in the event of a breakdown.
WHEN THE HOB IS FIRST INSTALLED
Once the hob has been installed, it is important to remove any protective
materials, which were put on in the factory.
The manufacturer will not accept liability, should the above instructions or
any of the other safety instructions incorporated in this book be ignored.
Instructions for the User Instructions for the User Instructions for the User Instructions for the User Instructions for the User
Lighting the burners Lighting the burners
Lighting the burners Lighting the burners
Lighting the burners
For easier lighting, proceed before putting a pan on the pan For easier lighting, proceed before putting a pan on the pan For easier lighting, proceed before putting a pan on the pan For easier lighting, proceed before putting a pan on the pan For easier lighting, proceed before putting a pan on the pan
support.
support.
support. support.
support.
To light a burner:
#
turn the relevant knob anti-clockwise to maximum
position, then push it down to ignite the burner.
#
Upon ignition, keep the knob pushed down
about 5 seconds
5 seconds 5 seconds 5 seconds 5 seconds. This will allow the
"thermocouple" (see the diagram - letter D) to
be heated and the safety device to be switched
off, otherwise the gas supply would be
interrupted.
#
Then, check the flame is regular and adjust it as
required.
To put the flame out, turn the knob to the
symbol
#
.
If the burner does not ignite, turn the control knob
to zero, and try again.
Operation Operation
Operation Operation Operation
!
A A A A A - Burner cap
B
B
B B
B - Burner crown
C
C C C C - Ignition electrode
D
D
D D
D - Thermocouple