
Always light the burner before you
put cookware.
To light the burner:
1.
Turn the control knob counterclock-
wise to the maximum position (
) and push it down.
2.
Keep the control knob pushed for ap-
proximately 5 seconds; this will let
thermocouple to warm up. If not, the
gas supply will be interrupted.
3.
Adjust the flame after it is regular.
If after some tries the burner does
not light, check if the crown and
its cap are in correct positions.
A
B
C
D
A)
Burner cap
B)
Burner crown
C)
Ignition candle
D)
Thermocouple
WARNING!
Do not keep the control knob
pushed for more than 15 sec-
onds.
If the burner does not light after
15 seconds, release the control
knob, turn it into off position and
try to light the burner again after
minimum 1 minute.
In the absence of electricity you
can ignite the burner without elec-
trical device; in this case approach
the burner with a flame, push the
relevant knob down and turn it
counter-clockwise to maximum
gas release position.
If the burner accidentally goes out,
turn the control knob to the off
position and try to light the burner
again after minimum 1 minute.
The spark generator can start au-
tomatically when you switch on
the mains, after installation or a
power cut. It is normal.
4.2
Turning the burner off
To put the flame out, turn the knob to the
symbol
.
WARNING!
Always turn the flame down or
switch it off before removing the
pans off the burner.
4.3
Operating electric zones
To switch on and increase the heat set-
ting turn the knob counterclockwise. To
decrease the heat setting turn the knob
clockwise. To switch off turn the knob to
the 0.
Power indicator is activated when electric
cooking zone is turned on, and will stay
on until electric cooking zone is switched
off.
4.4
Before first use (electric
zones)
Put cookware containing water on each
cooking zone, set the maximum position
and operate the appliance for 10 min.
This is to burn off the residue in the appli-
ance. After that, operate the appliance at
minimum position for 20 min. During this
period, an odour and smoke can occur.
This is normal. Make sure that the airflow
is sufficient.
After this operation, clean the appliance
with a soft cloth soaked in warm water.
4.5
Rapid hot plate
A red dot in the middle of the plate shows
a rapid hot plate. A rapid hot plate heats
up faster than usual plates.
The red dots are painted on the plates.
They can deteriorate during use and even
disappear completely after a period of
time. It does not have an effect on the
performance of the appliance.
36 www.electrolux.com
Содержание EGL6382NOX
Страница 60: ...www electrolux com shop 397234802 B 452012 ...