34
Charcoal filter
•
The charcoal filter should only be used if you
want to use the hood in its filtering function.
•
To do this you will need an original AEG
charcoal filter (see special accessories).
•
Replacing the charcoal filter
The charcoal filter must normally be replaced at
least once every year. This filter cannot be
washed or regenerated.
To guarantee proper absorption of odours the
working volume of the charcoal must be
proportionate to the hood air flow. In this case
the high quality of the charcoal will ensure
efficient odour removal for approximately one
year, assuming that the hood is used normally.
For this reason you should always use original
AEG filters only, making sure they are replaced
when necessary.
•
Mounting
1. Pull out the vapour catcher (Fig. 1 - A).
2. Remove first the rear then the front grease
filters.
3. Insert the charcoal filter into the lugs of the
holding frame above using the 2 red clips to
retain it below, press the red clips inwards, and
insert the charcoal filter in the holding frame.
Fig. 4.
•
Dismounting:
1. Press both red lugs upwards (towards the
inside of the housing) and remove the charcoal
filter downwards.
2. Clean the internal housing only with warm
washing-up liquid’ suds (never use any abrasive
cleaners, brushes, or scouring agents).
•
Always specify the hood model code number
and serial number when ordering replacement
filters. This information is shown on the
registration plate located on the inside of the
unit.
•
The charcoal filter can be ordered from the
AEG technical assistance service.
Changing the light bulb(s)
•
Disconnect the unit from the mains power
supply.
•
Pull out the drawer.
•
Open the lamp cover support.
•
Replace the old light bulb with a new light bulb
of the same kind.
•
Replace the lamp cover support.
•
If the light does not come on, make sure the
bulb has been screwed in correctly before
contacting the technical assistance service.
Fig. 4
Fig. 5
CLOSED
OPEN
CLOSED
OPEN
