Electrolux EFC9660, Руководство пользователя

Страница: 6 / 28

6 6
6 6 6 electr
electr
electr electr electrolux
olux
olux olux olux safety warnings
GB
For the installer For the installer For the installer For the installer For the installer
• When used as an extractor unit, the
hood must be fitted with a hose
having preferably the same diameter
as the outlet hole.
Attention:
Attention:
Attention: Attention: Attention: The hose is not supplied
and must be purchased separately.
• ••
•• When installing the hood, make sur
When installing the hood, make sur
When installing the hood, make sur When installing the hood, make sur When installing the hood, make sure
ee
e e
you observe the following minimum you observe the following minimum
you observe the following minimum you observe the following minimum you observe the following minimum
distance fr
distance fr
distance fr distance fr distance from the top edge of the
om the top edge of the
om the top edge of the om the top edge of the om the top edge of the
cooking hob/ring surfaces: cooking hob/ring surfaces:
cooking hob/ring surfaces: cooking hob/ring surfaces: cooking hob/ring surfaces:
electric cookers
electric cookers electric cookers electric cookers electric cookers 500 mm 500 mm 500 mm 500 mm 500 mm
gas cookers gas cookers gas cookers gas cookers gas cookers 650 mm 650 mm 650 mm 650 mm 650 mm
If the instructions for installation for
the gas hob specify a greater
distance, this must be adhered to.
• The national Standard on fuel-
burning systems specifies a maxi-
mum depression of 0.04 mbar in
such rooms.
• The air outlet must not be connected
to chimney flues or combustion gas
ducts. The air outlet must under no
circumstances be connected to
ventilation ducts for rooms in which
fuel-burning appliances are installed.
• The air outlet installation must comply
with the regulations laid down by the
relevant local authorities.
• When the unit is used in extraction
mode, a sufficiently large ventilation
hole must be provided, with
dimensions that are approximately
the same as the outlet hole.
• National and regional building
regulations impose a number of
restrictions on using hoods and fuel-
burning appliances connected to a
chimney, such as coal or oil room-
heaters and gas fires, in the same
room.
• Hoods can only be used safely with
appliances connected to a chimney if
the room and/or flat (air/environment
combination) is ventilated from
outside using a suitable ventilation
hole approximately 500-600 cm
2
large to avoid the possibility of a
depression being created during
operation of the hood.
• If you have any doubts, contact the
relevant controlling authority or
building inspector’s office.
• Since the rule for rooms with fuel
burning appliances is “outlet hole of
the same size as the ventilation hole”,
a hole of 500-600 cm
2
, which is to
say a larger hole, could reduce the
performance of the extractor hood.
• If the hood is used in its recirculation
mode, it will operate simply and safely
in the above conditions without the
need for any of the aforementioned
measures.
• When the hood is used in its
extraction mode, the following rules
must be followed to obtain optimal
operation:
- short and straight outlet hose
- keep bends in outlet hose to a
minimum
- never install the hoses with an
acute angle, they must always
follow a gentle curve.
- keep the hose as large as possible
(preferably the same diameter as
the outlet hole).
- the length should be no more than:
3 metres with one 90° bend
2 metres with two 90° bends
Bends of more than 90° will reduce
the efficiency of the hood and
reduce the airflow.
• Failure to observe these basic
instructions will drastically reduce the
performance and increase the noise
levels of the extractor hood.