Electrolux EFC9561X, Инструкция по установке и эксплуатации

Страница: 5 / 32

1. Using a spirit level mark a vertical centre line on the wall
where the hood is to be positioned, and a horizontal line
at the hood base position (refer diagram bottom left).
NOTE: The height of the underside of the hood body must
be a minimum of 600mm above an electric cooktop &
650mm above a gas cook top and a maximum height of
800mm (refer to table below).
Distance from hood base to top of hob
hob type minimum* maximum
gas 650mm 800mm
electric 600mm 800mm
* If the instructions of the hob specify a greater distance than the
minimum above, then that shall be the minimum height for installation
2. Mark the location for the wall and ceiling bracket fixing
points above the hood base using the hood base as the
reference point (refer diagram bottom left).
3. Install wall and ceiling mounting brackets with suitable
screws (to support a total weight of 30kg) to the wall at the
positions marked in diagram bottom left.
4. Remove the protective plastic film from the hood body
and hang hood on the mounting brackets then secure at
the anti-tilt locations as indicated in diagram bottom left.
Depending on the preferred installation/ducting mode,
follow step 5a or 5b below.
5a. Recirculating mode (Fig. a). Using the centre line, secure
the ceiling mount bracket to the wall using suitable
screws (screws not supplied). Attach the recirculating
T-piece to the ceiling mount bracket. Install flexible pipe
between T-piece and fan transition outlet. Use cable ties
or suitable duct tape to secure flexible pipe to T-piece.
NOTE:
When installed in recirculation mode, it is
recommended to use a carbon filter to prevent odours
being emitted back into the room.
OR
5b. Ducted mode (Fig. b). The canopy rangehood has been
supplied with flexible exhaust pipe and duct transition
piece, alternatively a 150mm dia. non-combustible flue
pipe can be used. Continue the centre line to the ceiling.
Attach the ceiling mount bracket on the centre line. Fit
preferred flue pipe to the fan transition duct.
100mm
344mm
303mm
37mm
155mm 155mm
71mm
324mm
349mm
374mm
399mm
523mm
ceiling
wall mounting
brackets
ceiling
mounted
bracket
hood
base
top
of hob
anti-tilt fixing points
168mm 168mm
(rear view of
hood)
(rear to wall)
46mm
(recommended area
behind flue cover for
power point location)
100mm
(rear view of
hood)
102mm
525mm
46mm
359mm
266mm
25mm
155mm 155mm
ceiling
wall mounting
brackets
ceiling
mounted
bracket
168mm168mm
anti-tilt
fixing points
(rear to wall)
138mm 138mm
lower back
edge of glass
top
of hob
(recommended area
behind flue cover for
power point location)
(b)
(a)