Electrolux EDW 1103, Руководство по обслуживанию

Страница: 30 / 30

Alarm Codes
Service Code
Family
(Platform specific)
Reason Type User visible User
indication
failure
code read
Action in case of failure happens
Dishwashers before
March 2017
User indication
Please OBSERVE that iBx family has different meaning depending on PBs and PB firmware versions
B0(DIVA2, PB100
before P100R230,
PB200 and PB300)
Turbidity sensor problem warning No Nothing ib0 (iH0) Turbidity flag set – cycle continuous Nothing
B0(PB100 after
P100R230, PB101
and PB150)
Turbidity sensor calibration
unknown error warning No Nothing ib0 (iH0) Cycle continues as though the dirt value to be considered is high Nothing
(PB100 after
P100R230, PB101
and PB150)
lose contact with the turbidity
sensor warning No
Nothing ib1 (iH1)
Cycle continues as though the dirt value to be considered is high Nothing
(PB100 after
P100R230, PB101
and PB150)
sensor not enough power
calibration warning No
Nothing ib2 (iH2)
Cycle continues as though the dirt value to be considered is high Nothing
(PB100 after
P100R230, PB101
and PB150)
sensor out of range calibration warning No Nothing ib3 (iH3) Cycle continues as though the dirt value to be considered is high Nothing
(PB100 after
P100R230, PB101
and PB150)
sensor too noisy calibration warning No Nothing ib4 (iH4) Cycle continues as though the dirt value to be considered is high Nothing
C0 No user interface detected stop No Nothing ic0 Cycle stop and continuous automatic if problem solved Nothing
Macs – bus communication stop Yes
iC1 ic1
Macs low level communication - Cycle stop and continuous automatic
if problem solved
iC0
Adsi – communication to ui stop Yes iC2 ic2 Cycle stop and continuous automatic if problem solved iC0
Motor control board comm stop Yes iC3 ic3 Command level communication - Cycle stop and continuous
automatic if problem solved
iC0
D0 Tacho problem warning No Nothing id0 Heating off up to end of cycle – motor to full speed – rta off Nothing
Tacho critical warning No Nothing id1 Heating off up to problem is solved – full speed – rta off Nothing
E0 Flow control positioning warning No Nothing iE0 Heating element will be switched off Nothing
F0 Sw fill limit reached Warning /
fill_limit
No Nothing iF0 No further water load up to next drain possible – rta off – cycle
continues up to end of cycle – is power fail saved
Nothing
SW Safety level reached stop Yes iF1 iF1 Cycle stop and continuous automatic if problem solved iF0
Technical Support – A.R.
Chapter
4
599 79 76 - 53 REV 1.0