SOI/DT 2003-12 dmm
8/50
599 36 20-08
4.3 Description of pushbuttons and LEDs
4.3.1
"NO BUZZER" pushbutton
This option can be selected only when the dryer is in "selection" mode (set-up).
Press this pushbutton to disactivate the buzzer function. The LED lights to indicate this selection. To
re-activate the buzzer function, press the pushbutton again; the LED will switch off.
Even when the
buzzer function is disactivated, the buzzer will continue to signal alarm conditions and warnings.
“NO BUZZER” (not only for the affected cycle)
Setting to be made during the selection phase (set-up):
press simultaneously for two seconds the pushbuttons 1/2 for the four-pushbutton control panel and
2/3 for the five-pushbutton panel.
To reset the buzzer press the pushbutton combination relative to the control panel until the buzzer
emits a “beep”.
4.3.2
"QUICK" pushbutton
Select this option to reduce the duration of the drying cycle selected.
The corresponding LED lights when the "QUICK" option has been selected. If the button is pressed
again, the LED will switch off to indicate that the option has been disactivated.
4.3.3
"DELICATE DRYING" pushbutton (half power)
This dryer features a heating group with two separate heating elements whose power varies
according to the model.
When this pushbutton is pressed once, the electronic control system switches off the lower-power
heating element, and the corresponding LED lights to indicate that the option has been selected. If
the pushbutton is pressed again, the LED switches off to indicate that the option has been
disactivated, and the heating element switches on again during the cycle.
4.3.4
"DELAYED START" pushbutton
The "DELAYED START" option must be selected before pressing START/PAUSE.
This option enables the user to delay the start of the drying cycle.
The delayed-start function consists of three combinations, depending on the configuration of the dryer:
Delay time (hours)
Led
Version 1
Version 2
Version 3
L4
3
6
9
L5
2
4
6
L6
1
2
3
Press the pushbutton to select the delay time. Each time the button is pressed, the time indicated by
the corresponding LED will change, starting from the maximum delay time and decreasing to the
minimum time; pressing the button again at this point will cancel the delayed-start option.
If START/PAUSE is pressed during the delayed-start countdown, the dryer goes into standby mode;
press START/PAUSE again to resume the countdown from the point at which it was interrupted.
4.3.5
"START/PAUSE" pushbutton
§
Start
When a drying programme has been selected using the programme selector, the LEDs for the three
phases (drying, cooling and - if featured - anti-crease/end of cycle) light and the START/PAUSE
LED flashes.
After selecting the desired option(s), press this button to start the cycle. The corresponding LED, as
well as the drying phase LED, remains lit.
§
Pause
If START/PAUSE is pressed while a drying cycle is being performed, the dryer interrupts the cycle
and the appliance goes to PAUSE mode; the corresponding LED flashes.
Certain options may be modified while the appliance is in PAUSE mode.
Press START/PAUSE again to resume the cycle from the point at which it was interrupted.
Содержание EDR1000NEW
Страница 2: ...SOI DT 2003 12 dmm 2 50 599 36 20 08 ...