Electrolux EDC 66150W, Руководство пользователя

Страница: 18 / 30

18 electrolux programme information
Programme information
Adjusting the level
of conductivity
Water contains, a variable quantity of limestone and mineral salts
of which quantities vary according to geographical locations thus
varying its conductivity values. Relevant variations of the
conductivity of the water compared to those prefixed by the
factory could slightly influence the residual humidity of the laundry
at the end of the cycle. Your dryer allows you to regulate the
sensitivity of the drying sensor based on conductivity values of the
water by using the following procedure.
T To o a ac cc ce es ss s a ad djju us sttm me en ntt m mo od de e::
1. Turn the programme selector dial to switch on the appliance.
2. In selection mode,press simultaneously the buttons
DRYNESS and START.
Press the buttons down until the pilot lights above each ones
begin to flash and one of the pilot lights indicating the drying
phase lights
, and remains it.
A Ad djju us sttiin ng g tth he e lle ev ve ell o off c co on nd du uc cttiiv viitty y:
Press the START/PAUSE button sequentially: the level of
conductivity is indicated by the phase pilot lights, which light
in various combinations as follows:
LED lit Conductivity Approximate value µS/cm
Low < 300
Medium 300-600
High >600
Normally, the appliance is factory-set to the highest level;
however, certain models may be configured differently.
M Me em mo orriiz ziin ng g tth he e n ne ew w s se ettttiin ng g::
Simultaneously press the buttons DRYNESS and START.
Press the buttons down until the pilot lights above each
ones stop flashing and the buzzer sounds.
O = Cancelling/OFF
To reset a programme and to switch off the machine turn
the selector dial to
O . Now a new programme can be
selected.
Objective
Implementation