Air conditioner cooling, but
room is too warm - NO ice
forming on cooling coil
behind decorative front.
Room too cold.
Fault codes.
Problem
Problem
Solution
Solution
1. Dirty air filter - air restricted. Clean air filter. Refer
to Care and Cleaning section.
2. Temperature is set too high. Set temperature to a
lower setting.
3. Air directional louvers positioned improperly.
Position louvers for better air distribution.
4. Front of unit is blocked by drapes, blinds,
furniture, etc. - restricts air distribution. Clear
blockage in front of unit.
5. Doors, windows, registers, etc. open - cool air
escapes. Close doors, windows, registers, etc.
6. Unit recently turned on in hot room. Allow
additional time to remove “stored heat” from walls,
ceiling, floor and furniture.
1. Set temperature too low. lncrease set
temperature.
2. Remote Sensing activated (on some models) and
remote control located in Hot Spot - Relocate
remote control or deactivate remote sensing.
1. If the display reads "AS" or "ES", a sensor has
failed. Contact your Authorized Electrolux Service
Center.
Air conditioner turns on
and off rapidly.
Noise when unit is cooling.
Water dripping INSIDE
when unit is cooling.
Water dripping OUTSIDE
when unit is cooling.
1. Dirty air filter - air restricted. Clean air filter.
2. Outside temperature extremely hot. Set FAN
speed to a faster setting to bring air through
cooling coils more frequently.
1. Air movement sound. This is normal. If too loud,
set to lower FAN setting.
2. Window vibration - poor installation. Refer to
installation instructions or check with installer.
1. Improper installation. Tilt air conditioner slightly to
the outside to allow water drainage. Refer to
installation instructions or check with installer.
1. Unit removing large quantity of moisture from
humid room. This is normal during excessively
humid days.
59 electrolux
solutions for problems
solution for problems
electrolux 60
E
N
G
E
N
G
