REMOVING THE CONTENTS OF THE DUST CONTAINER
Always operate the cleaner with the dust container installed.
1. Remove the dust container by using the open button on the handle.
2. Remove the filter set by pushing the button.
3. Remove the contents of the dust container.
2. Insert the filter set back into the dust compartment.
1. Insert the dust container back into the cleaner by pressing it down until
it clicks.
Note: Empty the dust container even if it is not full (the filters may be
blocked). Also replace after using carpet-cleaning powder.
REPLACING THE FILTERS
Filters should be replaced twice a year.
Disconnect from electrical outlet before cleaning filters.
Your cleaner is fitted with an electronic filter indicator. Before commenc-
ing cleaning, without the hose attached, check the filter indicator. If illumi-
nated, clean or replace filter, if not, attach the hose, extension tubes and
accessories as normal and continue cleaning.
NB: It is normal for the indicator light to illuminate during cleaning
Replacing the motor filter
1. Remove the dust container by using the open button on the handle.
2. Remove the filter set by opening the button.
4. Remove the filter with grill from its holder.
5. Remove the filter from the grill, and put a new one into it.
4. Put the filter with grill back into its place.
Replacing the micro filter
6. Open the filter grill to remove the exhaust filter.
Take the filter out of its place.
Put a new filter into its place, then close the filter grill.
Motor and microfilter reference number:
EF
75
Replacing or cleaning the cartridge filter
1. Remove the dust container by using the open button on the handle.
2. Remove the filter set by pushing the button.
7. Remove the protector mesh from the cartridge filter by pulling it out (A).
8. Remove the cartridge filter by turning it counter-clockwise (A) and pull
it out (B).
9. Shake the dirt from the filter and the mesh into a bin, if necessary the
filter and mesh can be rinsed, with cold water, under a tap.
10. Air dry them for approximately 24 hours, to ensure it is completely dry
before re-using. Avoid direct sunlight and extreme drying circustances.
If you wish to use your appliance while the cartridge filter is drying,
you may use the extra cartridge filter inserted in the
packaging box (Z7109, Z7110, Z7119)
.
8. Insert the cartridge filter into its place (B) and turn it clockwise (A).
7. Insert the protector mesh into its place by pushing it onto the cartridge
filter (B).
2. Insert the filter set back into the dust container.
1. Insert the dust container back into the cleaner by pressing it down until
it clicks.
Cartridge filter reference number:
EF
75
b.
Note: Do not use cleaning agents and avoid touching the delicate filter
surface.
1
2
3
4
5
6
8
5
A
B
7
A
B
9
10
z71xx_ifu.qxp 2005.11.11. 11:37 Page 5
