6
Operating and Installation
Instructions for your
Electrolux Wine Cellar
Introduction
Thank you for choosing the Electrolux Wine Cellar.
Please read the following instructions carefully before
installing your new wine cellar. We trust you will be
completely satisfied with your purchase.
The wine cellar must be installed and used according
to these instructions in order for it to operate correctly
and economically.
Transit damage
Inspect the wine cellar for transit damage. You must
report any damage the company responsible for the
delivery within the legal or stated time for this type of
product. If there is no such established report time, the
damage must be reported within seven days of deliv-
ery.
Data plate
Check the data plate, inside the wine cellar at the top
left, to ensure you have received the right model.
The data plate shows details that you will need to
quote if you have to contact service personnel. It is a
good idea to make a note of them here.
Model designation .
Product number .
Serial number .
Voltage .......
Installation
Please follow these installation instructions:
For best performance, air needs to circulate freely
over the cooling unit behind the wine cellar. The free-
standing design of the cellar means that it should
stand at least 25 mm from the rear and side walls.
Allow a clearance of at least 100 mm above the wine
cellar.
Adjust the feet of the wine cellar so that it stands in a
vertical position in both directions. Use a spirit level if
necessary.
1. Remove the transport pallet on which your wine
cellar rests.
2. Adjust the feet to allow a 30 mm clearance under
the wine cellar.
3. Attach the steel rod using the two screws at the top
back on each side of the cellar. The rod ensures the
correct distance to the wall behind.
4. For optimum performance, please place your wine
cellar far away from any source of heat (radiator,
cooker or intense sunlight).
5. Check that the charcoal filter is in place at the top
left corner inside the wine cellar.
6. Fit the door handle to the door. The door frame has
pre-drilled holes on its side(s).
Please note that it must be possible to open the
wine cellar door at least 90° to allow the sliding
shelves to be pulled out.
30 mm
FIG. 1
25
25
Wall
Wall
Rear
Steel rod
Steel rod
FIG. 2