Electrolux CGES3065P series, Руководство по обслуживанию, Страница: 43 / 53

3-21
Section 3 Electronic Control Guide
Removing and Replacing the Oven Door
CAUTION
The door is heavy. For safe, temporary storage, lay the
door flat with the inside of the door facing down.
To remove oven door :
1. Open oven door completely, horizontal with floor (See
Figure 37 ).
2. Pull the door hinge locks on both left and right door
hinges down from the oven frame completely towards
the oven door (See Figure 38 ). A tool such as a small
flat-blade screwdriver may be required.
3. Firmly grasp both sides of oven door along the door
sides. Do not use the oven door handle (See Figure 39 ).
4. Close the door to approximately 10 degrees from the
door frame (See Figure 39 ).
5. Lift the oven door hinge arms over the roller pins located
on each side of the oven frame (See Figure 40 ).
To replace oven door
:
1. Firmly grasp both sides of oven door along the door
sides. Do not use the oven door handle (See Figure 39 ).
2.
Holding the oven door at the same angle as the removal
position, seat the hook of the hinge arm over the roller
pins located on each side of the oven door frame (See
Figure 39 and Figure 40 ). The hook of the hinge arms
must be fully seated onto the roller pins.
3. Fully open the oven door, horizontal with floor (See
Figure 37 ).
4. Push the door hinge locks up towards and into the oven
frame on both left and right oven door hinges to the
locked position (See Figure 38 ).
5. Close the oven door.
IMPORTANT
Special door care instructions - Most oven doors contain
glass that can break. Do not close the oven door until all
the oven racks are fully in place. Do not hit the glass with
pots, pans, or any other object. Scratching, hitting, jarring,
or stressing the glass may weaken its structure causing an
increased risk of breakage at a later time.
Oven door
hinge
locations
Figure 37: Door hinge location
LOC
K
Figure 38: Door hinge locks
about
10°
hinge
oven
door
Figure 39: Holding door for removal
roller
pin
hinge
arm
Figure 40: Replacement and location of hinge arm
and roller pin