29
Your appliance needs air
For safety reasons, minimum
ventilationmust be as shown Fig.
Attention:
keep
ventilation
openings clear of obstruction;
100 mm
10 mm
10 mm
A
B
NP007
Rear spacers
In the bag with the documentation,
there are two spacers which must be
fitted.
Slacken the screws and insert the
spacer under the screw head, then
re-tighten the screws.
PR153
Fitting the Door Handles
1.
Screw the top handle
bracket to the handle rod
(1). Fit the bottom handle
bracket on the lower left-
hand side of the door (2).
2.
Fit the top handle bracket
on the top left-hand side
of the door (3) and screw
the handle rod to the
bottom handle bracket (4).
Attention!
Do not overtighten the
screws (max. 2 Nm) as you
may damage the door
handles.
40
Switching off the appliance
If the appliance is not going to be used for an extended period:
1.
Remove all deep-frozen packages as well as ice trays.
2.
Switch off the appliance by holding down the ON/OFF button.
3.
Remove the mains plug or switch off or turn out the circuit breaker or fuse.
4.
Clean thoroughly (see section: “Cleaning and Care”).
5.
Leave the door open to avoid the build up of odours.
Energy Saving Tips
• Do not install the appliance near cookers, radiators or other sources of
warmth. High ambient temperatures cause longer, more frequent
operation of the compressor.
• Ensure sufficient air circulation and exhaust at the appliance base and at
the back wall of the appliance. Never cover air vent openings.
• Do not place warm foods into the appliance. Allow warm foods to cool first.
• Only leave door open as long as necessary.
• Do not set temperature any colder than necessary.
• Put frozen food in the fridge to defrost. The cold in the frozen food will
then be used to cool the fridge.
• Keep the heat emitting condenser, the metall grille on the rear wall of
your appliance, always clean.
