Water hardness
Water hardness setting
°dH
°TH
mmol/l
Clarke
manually
electronically
< 4
< 7
< 0,7
< 5
1
1)
1
1)
1) No use of salt required.
You must set the water softener manually and electronically.
Manual adjustment
The appliance is set at the factory at position 2.
1. Open the door.
2. Remove the lower basket.
3. Turn the water hardness dial to position 1
or 2 (refer to the chart).
4. Install the lower basket.
5. Close the door.
Electronic adjustment
The water softener is set at the factory at level 5.
1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press and hold the programme selection/cancel button.
4. Release the programme selection/cancel button when programme indicator light A
starts to flash and programme indicator light B comes on.
5. Wait until programme indicator light B goes off.
– Programme indicator light A starts to flash.
– The end-of-programme indicator light starts to flash.
6. Press the programme selection/cancel button one time.
– Programme indicator light A starts to flash.
– The setting function of the water softener is activated.
– The end-of-programme indicator light flashes to show the level of the water soft
-
ener.
Example: 5 flashes, pause, 5 flashes, pause, etc. = level 5.
7. Press the programme selection/cancel button one time to increase the water softener
level by one step.
8. Press the on/off button to save the operation.
32
Setting the water softener
Содержание AEG FAVORIT 35020 VI
Страница 75: ...75 ...