Electrolux A15931301, Инструкция по использованию и уходу

Страница: 13 / 20

13 Care and Cleaning
Winterizing
A dishwasher left in an unheated place
should be protected from freezing. Have a
qualified person do the following.
To disconnect service:
1. Turn off electrical power to the
dishwasher at the supply source by
removing fuses or tripping circuit
breaker.
2. Shut off water supply.
3. Place a pan under the inlet valve.
Disconnect water line from the inlet
valve and drain into pan.
4. Disconnect drain line from pump and
drain water into pan.
To Restore Service:
1. Reconnect the water, drain, and
electrical power supply.
2. Turn on water and electrical power
supply
3. Fill detergent cup and run the
dishwasher through a HEAVY wash
cycle.
4. Check connections to make sure they
do not leak.
CAUTION
Freezing temperatures may cause
water lines to rupture. Be sure all supply
lines to and circulating lines within your
dishwasher are protected. Failure to do
so could result in property damage.
NOTE
See Installation Instructions for more
details.
4. Remove any dirt or other remains from
the filters, and then rinse them under
running water.
5. Reassemble the filters in the reverse
order of the disassembly, replace the
filter insert, and rotate clockwise to the
close arrow.
CAUTION
If the filter insert is not closed properly,
its performance will be decreased.
Cleaning the lower spray arm
If your dishwasher does not seem to be
cleaning adequately or the spray arm
nozzles seem clogged, the lower spray
arm can be removed and cleaned. Remove
spray arm carefully to avoid damage.
To remove lower spray arm:
1. Check whether the nozzle holes are
clogged by food particles.
2. If cleaning is needed, remove the
spray arm by pulling it upwards.
3. Clean the nozzles, and then push the
spray arm back into place.
4. Rotate the spray arm to check that it
is properly in place.
Cleaning the door gasket
If the dishwasher door is not closing
properly or if water is leaking from the door
during the cycle, check that door gasket is
clear of debris. If needed, clean the door
gasket with a damp cloth to remove food
particles and ensure a tight seal.