Electrolux 95 EX-T, Инструкция пользователя

Страница: 13 / 20

1 3
Cleaning and Maintenance
Before each operation, disconnect the unit.
This appliance cannot be cleaned with steam
or with a steam cleaning machine.
Cleaning the oven
Clean carefully the oven cavity after use when it is still
warm. In fact, at this moment it is easy to take off deposits
of fat or other substances such as fruit juice, sugar
particles or fat. You can use warm detergent water or one
of the appropriate spray oven cleaners. Do not direct the
spray at the mat steel parts as this could damage them
and always follow the manufacturer's instructions. Clean
the oven accessories (grate, grid-plate etc.) with warm
water and detergent.
Remove possible incrustations with a slightly abrasive
powder. Never line any part of the oven with aluminium foil.
It would result in an accumulation of heat which might
damage the cooking results and also damage the enamel.
Controls - Sundries
Periodically check the condition of the flexible pipe of gas
connection and make it replaced by skilled technicians
as soon as it shows abnormalities. Annual replacement
is recommended.
In ranges with cylinder holder, do not use this space to
leave a non-connected or an empty cylinder.
Cylinder holder
The units equipped with cylinder holder must be installed
in such a way to ensure a sufficient ventilation inside the
holder itself; otherwise there is the chance to install inside
the holder, instead of the cylinder, (on request) a set of
grills and containers, converting the cylinder holder into a
comfortable closet.
Cleaning the oven door
Before cleaning the oven door, we recommend you to
remove it from the oven.
Proceed as follows:
1. open the oven door completely;
2. find the hinges linking the door to the oven (see
picture 1);
3. unlock and turn the small levers located on the two
hinges (see picture 2);
4. handle the door by its left- and right-hand sides,
then slowly turn it towards the oven until it is half-
closed (see picture 3);
5. gently pull the oven door off its site (see picture 3);
6. place it on a steady plan;
Clean the oven door glass with warm soapy water and a
softh cloth only. Never use harsh abrasives.
Once the cleaning is carried out, refit the oven door,
following the procedure in reverse.
Fig. 14
Oven lamp replacement
Disconnect the appliance. Unscrew the lamp (Fig.
14) and substitute it with another fitting for a higher
temperature (300°C) with the folowing
characteristics:
Tension:
230 V (50 Hz)
Power: 15 W/25 W
Convection: E14
1
2
3
! !
! ! !