Electrolux 942001293 00, Руководство по обслуживанию

Страница: 2 / 43

Page 2
SERVICE TEST
WSF67251S, WSF67381S & WSU67381S
NOTE: Only the Service Technician can execute this procedure.
Accessing Service Test:

Press and hold the Start/Pause button with the Dishwasher turned OFF.

Power the machine ON while continuing to hold Start/Pause button in for at least six
seconds (6)

The Service Test starts automatically displaying “SP 01” .

Release the Start/Pause button.

All LED’s blink for approximately 2 seconds (LED test).

If a failure code has occurred, it is stored within the PCB’s memory and displayed in the
first 6 seconds of the Service test.
Up to 3 codes are stored in memory. Failure codes would
have a prefix number of 1, 2, and 3 with 1 being the latest code and so on.

If an error occurs during the Service Test, the error code displays at its completion.
* During the Service Test an unsuccessful heating failure test (F8) works with reduced time to
diagnose (first measurement at 2min20sec and the second measurement at 4min20sec)
NOTE:
a. If you open the door during a Service Test, the Start/Pause led blinks and “SP” displays
on the LED panel.
b. If you press the Start/Pause button during a Service Test, the first wash program starts.
Step Displayed Time Tested Load
0
Last
3
Fault Code
s
6 sec
Up to 3 codes are displayed during
this time
SP01 Drain 6 sec Drain pump.
SP02 Fill ~1 min Flow meter; Inlet Valve;
SP03 Fill+ Wash Flow meter; Inlet Valve; Pressure Switch;
SP04 Turbidity Sensor* 30 sec
Measurement sensor of water turbidity
(*if fitted)
SP05 Wash 1 min
Circulation pump; Regeneration Valve;
Detergent Dispenser.
SP06 Wash+ Heat* 5 min Heater (PSW); NTC; Diverter (position).
SP07 / SP08
Regeneration Valve* /
Turbo Fan
1 min
*Regeneration Valve (N/A) + Turbo Fan
(Turbo Fan only WSF & WSU67381S)
9 Drain 20 sec Drain pump; Pressure Switch.
10 End - Code Error or End LED