Professional Series Cooktop LPG Conversion Kit
Page 7
STEP 7 Replace Main Orifices
7-1 Remove the two screws that hold the left rear
burner base to the chassis.
7-2 Hold the shutter connector with the 8”
adjustable wrench. Remove the air shutter using
the 6” adjustable wrench.
7-3 Hold the shutter connector with the 8”
adjustable wrench. Remove the main orifice
from the shutter connector using the 10 mm
open-end wrench.
7-4 Replace the main orifice with the appropriate
size from Table 7-1. Match both the model
number and the burner location. The main
orifice’s size is stamped on its side. The shutter
and the burner base will be re-assembled after
pressure testing.
7-5 Check to make sure that the compression nut is
tightened into the back of the shutter connector.
7-6 Repeat steps 7-1 through 7-5 for the remaining
burners.
Figure 7-1 Main Orifice Conversion
Burner
Location
E36GC76EPS
(36-Inch)
E48GC76EPS
(48-Inch)
Left Rear
112
112
Left Front
86
86
Right Rear
86
86
Right Front
112
112
Center Rear
118
118
Center Front
118
118
Table 7-1 Main Orifice Sizes (X 100 mm)
Burner base
Air shutter (remove)
Main orifice
Shutter connector
Compression nut
