Electrolux 5995436457, Руководство по обслуживанию

Страница: 25 / 28

25
Problem
Cause Correction
13. Unit produces shallow or
incomplete cubes or the ice fill
pattern on the grid is incomplete.
Cause
14. Not freezing compressor not
running / fan operating.
Cause
15. Not freezing (compressor and
fan not operating)
16. If the unit has a drain pump.
Cause
a. Low water level.
b. Low water pressure.
c. Unit is not level.
d. Operating unit without back or
front panel.
e. Bad thermister.
f. Bad control board.
a. Bad overload (open).
b. Bad compressor.
a. No electrical power to unit.
b. Rocker switch defective or wired
incorrectly.
a. Drain tube kinked or obstructed.
b. Bad pump. Diagnose by
bypassing the pump. Pull both
pink wires from control board and
jump the two terminals together.
If unit starts up, then the pump is
bad.
c. Open wire in wiring harness.
Cause
a. Check that standpipe is fully
seated inside water trough.
b. Check water pressure into water
valve (pressure should be 20 to
120 psi).
c. Level unit to assure even water
flow. Uneven water flow will
reduce ice rate and cause
incomplete cubes. See Leveling
Instructions in manual.
d. Install back or front panel. The
unit will harvest ice according to
temperatures of tubing at
condensing coil. Increased air
flow will give the thermister false
information. This info could cause
the ice to eject prematurely.
e. Replace thermister.
f. Replace control board.
Remedy
a. Replace overload.
b. Replace compressor.
Remedy
a. Make sure unit is plugged in and
outlet has power.
b. Make sure switch is wired
correctly and set in “ICE” position.
a. Clear the tubing. If water cannot
drain from pump, unit will shut
down due to safety design of
pump.
b. Change pump. Jumping the two
terminals on control board
together with a jumper wire will
eliminate pump from the circuit.
c. Trace defective wire and repair
or replace parts accordingly.