18
E.4
Accessing the appliance’s internal
components
F
INSTALLATION AND ASSEMBLY
F.1
Introduction
WARNING
Refer to “
To ensure correct operation of the appliance and maintain safe
conditions during use, carefully follow the instructions given in
this chapter.
Check and, if necessary, level the appliance after positioning.
Incorrect levelling can cause appliance malfunctioning.
F.2
Customer's responsibilities
The tasks and works required of the Customer are:
• check the floor planarity on which the appliance is placed;
• arrange an earthed power socket of suitable capacity for the
input specified on the data plate;
• prearrange a high-sensitivity manual-reset magneto-ther-
mal circuit-breaker;
• prearrange a device lockable in the open position for the
connection to the power supply.
• Do not install the unit in environments where temperatures
may fall below 0
℃
[32
℉
] or rise above 40
℃
[104
℉
].
NOTE!
For information regarding the electrical connection,
refer to “A.11
“.
F.3
Before installation
Depending on your model, prepare the following before the
appliance is installed and positioned correctly:
• Fastening elements, i.e. drill holes and insert dowels. You
can find accompanying notes in the relevant sections on F.8
• Prepare water, gas and electrical connections and install a
shut-off valve, if necessary.
F.4
Installing on concrete plinth
Packaging should only be removed immediately before the
unit is installed.
Keep the unit on the transport pallet until it is at its final location.
1. Transport the appliance on its transport pallet directly in
front of the point of installation.
2. Remove the pre-cut plate at the bottom of the appliance.
(for access, see E
1
1
2
2
4
3
2
3
4
4
4
4
6
5
5
1
1
1
