Electrolux Professional 603877, Инструкция по установке и эксплуатации

Страница: 25 / 46

25
I.4.11 CONNECTIVITY
1 2 SIGNAL CONTROL
SELECTION
This function allows to con-
nect the appliance to the
Service remotely. The Serv-
ice will be able to check any
errors that may arise in the
appliance. It is advisable to check the
signal quality before putting
the appliance in remote.
3 SIGNAL READING 4 REMOTE CONTROL
ACTIVATION
This screen displays the Wi-Fi signal power and the
Connecting Board status. Confirm to exit.
5 REMOTE CONTROL
CONFIRMATION 6 REMOTE CONTROL
RUNNING
If it is necessary to interrupt the remote connection with the
Service press simultaneously the buttons “7“ and “8“ and
go straight to step 8 CONNECTION EXIT.
7 REMOTE CONNECTION
ENDED 8 CONNECTION EXIT
I.5 Advanced settings
I.5.1 Access to Advanced settings
To access the “Advanced Settings“ , insert the required
password.
1. Press simultaneously buttons “7“ and “8“ (or – and –) for
two seconds to activate the password menu.
2. Press the corresponding buttons in the correct sequence
to insert the password.
NOTE!
Only the Chef can access to the Advanced settings.
I.5.2 PROGRAM SETTING - Single Phase
1 2
3
Full program duration
• Increase or decrease the full duration of
the program.
Microwave phase duration
• Increase or decrease the full duration of
the phase.
Set microwave starting
• You can set the microwave start at the
beginning or at the end of the program.
NIU STATUS:
Installed
NOT JOINED
MODE: STATION
WIFI SIGNAL:
LINK_QUALITY_UNDEFINED
NO YES
EXIT ?
Mw
Mw
OFF
0:20
Mw
Mw