24
Connections for automatic detergent dispenser
(Figure 17)
Figure 17 Automatic dispenser arrangement
The wash tank has a (plugged) hole “N” (Ø 22 mm) for
fitting a sensor which measures the concentration of
detergent.
There is also a (plugged) hole “O” (Ø 22 mm) available
for introduction of detergent.
Electrical connections for automatic detergent and
rinse-aid dispensers.
Terminals are available on the power supply terminal
board for the electrical connection of external dispen-
sers working at 220-240 V. Max. power 30 VA.
Figure 18 Detergent dispenser terminal block
•
Connect the
detergent dispenser
between termi-
nals 7 and 9. These connection points are live for a
set time during filling of the tank and at the start of
the wash cycle (see paragraph H4 “Setting the
dispensers”).
Figure 19 Rinse aid dispenser terminal block
•
Connect the
rinse-aid dispenser
between termi-
nals 8 and 9. These connection points are live
during filling of the tank and at the end of the rinse
cycle for a set time (see paragraph H4 “Setting the
dispensers”).
Adding the detergent (for models without auto-
matic dispenser).
Pour a non-foaming detergent into the tank when the
water has reached optimal washing temperature.
MANUAL ACTIVATION
Whenever the detergent containers are replaced, it
may be necessary to activate the dispensers manually
in order to fill the hoses and eliminate any air. Simulta-
neously press the buttons, as shown in the figures
below. If necessary, repeat this operation several
times.
H4
Setting the dispensers
All operations should be carried out with the appliance
switched on but no cycle selected.
Press the On/Off button ("A" - Table 2 "Control panel")
and Wash cycle 1 button ("G" - Table 2 "Control panel")
together for 5 seconds, to access the programming
mode and the display shows the parameter "
".
Press the button ("N" - Table 2 "Control panel") twice to
access the detergent and rinse aid adjustment para-
meters.
N
S
R
O
DETERGENT DISPENSER
RINSE-AID DISPENSER
Содержание 506048
Страница 32: ...34 ...