Electrolux Professional 506048, Руководство пользователя, Страница: 12 / 32

14
• Carefully remove the protective film from the outer
panels without tearing it, to avoid leaving traces of
glue (Figure 8). .
• Adjust the equipment by turning the special adjust-
able feet and making sure it is perfectly level, both
lengthwise and crosswise (Figure 9).
Figure 9 Feet adjustment
F5 Disposal of packing
All materials used for packing are environmentally
compatible. They can be safely kept, and recycled or
burnt in a special waste incineration plant. Plastic parts
subject to possible recycling are marked as follows:
Parts in wood and cardboard can be disposed of
respecting the current regulations in the country of
use.
F6 Plumbing connections
Install the machine water filling and drain pipes accord-
ing to the plumbing circuit and installation diagrams
given below.
• Connect the appliance water supply pipe “HWI”
(see paragraph F6.2 Installation diagrams) to the
mains, fitting a cut-off cock “X”, the filter provided
“Y” and a pressure gauge “Z” between the appli-
ance and the mains (Figure 10). Carefully seal all
the components to prevent leaks in the pipes.
Figure 10 Feed pipe connection
• Check that the dynamic water supply pressure ,
measured between the appliance and the main, is
between 50 and 700 kPa (test while dishwasher
tank or boiler is filling with water).
If the pressure is too high, fit a suitable pres-
sure reducer on the inlet pipe.
• Connect the waste outlet pipe “D” (see paragraph
F6.2 Installation diagrams) to the main drain pipe,
fitting a trap, or place the outlet pipe over an S trap
set into the floor.
Figure 8 Removing the film
polyethylene: outer wrapping, instruc-
tion booklet bag.
polypropylene: roof packing panels,
straps.
polystyrene
foam: corner protectors.
3
2
1
3
2
1
PE
PP
PS
3
2
1
Z
Y
X