Electrolux Professional 10 GN 1/1, Руководство по установке

Страница: 34 / 46

34
• If steam from the ventilation pipe cannot be directed into an
exhaust hood or a ventilating ceiling, there must be at least
500 mm clearance space above the device.
• Position the appliance on a flat surface.
If necessary, adjust the height of the worktop by means of
the adjustable feet (if available).
CAUTION
The appliance must be level.
F.3 Tabletop models
For safety reasons, tabletop models should only be placed on
top a manufacturer-original oven stand or cupboard structure.
Choose the appropriate structure in the accessories catalogue
according to your model.
Mounting onto an oven stand (size GN 1/1 – 2/1)
1. Replace the oven feet with the special feet supplied with
the oven stand accessory.
2. Place the appliance onto the oven stand by inserting the
locating feet into the tubular uprights.
Mounting onto a cupboard (sizes GN 1/1 – 2/1)
1. Disassemble the rear panel “B“ and control panel “A“ (if
expected);
2. Replace the oven feet with the special feet supplied with
the cupboard accessory;
3. Place the appliance onto the cupboard by inserting the
locating feet into the tubular uprights;
4. Refit the control panel “A“ and the rear panel “B“.
5. Proceed with the oven connections.
IMPORTANT
The connection pipes of the oven can be run
either on the back either on the side.
• remove and replace the panels “C“ and “D“
between them;
• remove the pre-cutted plates “E“ and “F“ to let
the drain pipe pass through the hole on the
back or at the side;
F.4 Stacking installations
The following tables indicate the possible appliance combina-
tions for stacking installations.
min. 500 mm
A
B
E
F
C
D