Operating I nstructions
Operating I nstructions
( continued)
.
d
e
v
r
e
s
e
r
s
t
h
g
i
r
ll
A
.
c
n
I
,
s
t
c
u
d
o
r
P
e
m
o
H
x
u
l
o
r
t
c
e
l
E
9
0
0
2
Note: This feature can be activated from the remote control ONLY, the unit must be in a cooling mode.
To activate the remote sensing feature, point the remote control towards the unit and press the
Remote Sensing
button. Next, use
the “ ” buttons to set the desired temperature at the remote. (Note that the set temperature will only be displayed on the unit
itself ). The LI GHT on the unit control will illuminate to indicate it receives the signal. The LI GHT on the remote control will pulse each time
it sends a signal. lt will periodically send this signal until the feature is deactivated by pressing the remote sensing button again. lf the unit
does not
receive
the
remote
sensing signal during any 7 minute interval, the Remote Sensing feature will halt until the unit receives signal
from the remote control again.
The display on the remote control indicates the temperature at the remote ONLY.
NOTE: The Remote Sensing function can be terminated either by pressing the Remote Sensing button again or the main ON/ OFF button on
the unit.
REMOTE SENSI NG FEATURE
( on some models)
：
Remote Sensing indicator
DO THI S:
PRESS REMOTE
SENSI NG BUTTON
NOTE: Remote display
is actual temperature
at remote control only
NOTE: Unit display shows the set temperature
10
TI MER: DELAY STOP/ START FEATURE
YOU WI LL SEE HOW MUCH TI ME I S CHOSEN:
THEN
DO THI S:
PRESS
UP/ DOWN BUTTONS
FI RST
DO THI S:
PRESS
TI MER BUTTON
To delay stop(or start), press the Timer button when the unit
is power-on(or power-off), then the "timer off" indicator(or
"timer on" indicator) will illuminate. Then adjust timer setting,
tap or hold the UP arrow ( ) or the DOWN arrow ( ) to
change delay timer at 0.5 hour increments, up to 10 hours,
then at 1 hour increments up to 24 hours. The setting will be
confirmed automatically in 5 seconds, then the control will
count down the time(8, 7.5, 7, etc.) left, and all other settings
will remain the same as they were before the timer setting is
confirmed, until stop(or start).
Setting combination of “delay stop delay start” or
“delay start delay stop” is workable. Both "timer off"
indicator and "timer on" indicator will illuminate then.
The timer setting can be canceled by either pressing and
holding the timer button for 2 seconds, or pressing the power
on/ off button at any time to turn off the unit directly.
turn off
turn on
Содержание Frigidaire
Страница 16: ......
