Go-Go Dancer - INSTRUCTIONS
15
M O D E L S
82
Fasten the Receiver to the bottom of the Fuselage with
double-sided foam tape just ahead of FF3. Mount the Elevator and
Rudder Servos upside-down as shown on the drawing.
83
Cover the Fuselage Top and Sides.
84
Glue the 1/32" plywood Elevator Control Horn (EH) on the
inside edge of the right Elevator half.
85
Use 3/4" wide strips of clear packing tape to join the top of
the Elevator to the Stabilizer.
86
The Elevator Pushrod should be run through the upper slot
on the right side of the Fuselage. The Pushrod should pass through
the small holes in each of the Fuselage Formers (FF6 – FF9). Use the
supplied Du-Bro hardware to connect the Pushrod to the Elevator
Horn. Use a "Z" bend at the Servo Arm connection. Adjust Elevator
alignment by bending the Pushrod "V" adjustment.
87
Glue the 1/32" plywood Rudder Control Horn (RH) on the
bottom left side of the Rudder.
88
Use 3/4" wide strips of clear packing tape to join the Rud-
der to the Vertical Stabilizer on the right side.
89
The Rudder Pushrod should be run through the lower slot
on the left side of the Fuselage. The Pushrod should pass through
the small holes in each of the Fuselage Formers (FF6 – FF9). Use the
supplied Du-Bro hardware to connect the Pushrod to the Rudder
Horn. Use a "Z" bend at the Servo Arm connection. Adjust Rudder
alignment by bending the Pushrod "V" adjustment.
90
Run the Receiver Antenna out through the lower slot on
the right side of the Fuselage.
91
Glue the Aileron Horns (AH) to the inside edge of both
Ailerons.
Note
: The Horns should be flush with the bottoms and
stick above the Ailerons.
92
Use 3/4" wide strips of clear packing tape to join the
Ailerons to the Wing.
93
Install the Aileron Servos and connect the Pushrods. Adjust
the Pushrods so that the bottom of the Ailerons are level with the
bottom of the Wing.
Note
: You will have to disconnect the pushrods to the Ailerons before
you can remove the wing.