eSKA - INSTRUCTIONS
M O D E L S
4
Locate the laser cut 3/32" Balsa Ailerons, Aileron Spars
and Aileron Ribs. Glue Aileron Spar To Each Aileron. Glue Aileron
Ribs AR2 through AR9 in notches of Ailerons.
Note:
Each Aileron is
marked with either an "L" for Left or "R" for Right. This marking is
on the bottom of each Aileron. Ailerons are built bottom-side-up.
42
Trim end of Aileron Spars and glue Aileron Rib 1 and 10 in
place at each end of Aileron.
43
Sand Ribs flush with Aileron Spar. You should also sand the
Trailing Edge of the Ribs and Ailerons down to 1/16" at the trailing
edge. Bevel the bottom edge of each Aileron as shown on the plans.
Use sanding block and work carefully. You should bevel the edge 40º
to allow for full down Aileron travel.
Note:
The Wing and Ailerons should weigh about 1.5 ozs.at this
time. Set Wing and Ailerons aside for later.
Fuselage Construction
44
Cover the Fuselage area of the plans with wax paper.
45
Locate the laser cut 3/32" Fuselage Sides (FSL & FSR) and
place the bottom edges together over the plans. Each Fuselage Side
is marked with the words Left or Right near the front along the top
edge. Left and Right are from the pilot position looking forward.
46
Glue the laser cut 1/32" Plywood Fuselage Doublers (FDL &
FDR) to the inside of each Fuselage Side. FDL should be used on the
Left Fuselage Side and FDR should be used on the Right Fuselage
Side. They are different because of the 1º of right thrust.
Tip:
You can use the Motor Mount (AMM), Fuselage Former (FF1)
and Landing Gear Mount (LGM1) to help align each Doubler/Brace.
47
Glue laser cut 1/32" Plywood Landing Gear Mount Brace
(LGMB) to inside of Fuselage Sides.
48
Glue the laser cut 1/32" Plywood Hatch Hook Reinforce-
ment (HHR) and laser cut 1/8" Lite-Ply Hatch Hook (HH) to each
Fuselage Side.
Important:
Make sure that the open end of the
Hatch Hooks (HH) points down toward the Fuselage bottom edge.
49
Push laser cut 1/8" Lite-Ply Astro Motor Mount (AMM) into
Left Fuselage Side holes. Do not glue.
5
Push the 1/8" Lite-Ply Fuselage Former 1A (FF1A) and the
1/8" Lite-Ply Landing Gear Mount 1 (LGM1) into Left Fuselage Side
holes. Do not glue. You may have to fit both of these into the hole as
an assembly.
5
Push the 1/8" Lite-Ply Fuselage Former 2 (FF2) into the Left
Fuselage Side. Do not glue.
52
Push the 1/8" Lite-Ply Elevator Servo Mount (RESM) into
the Left Fuselage Side and over FF2.
