User Manual SCA-SE-30-06
ElectroCraft
®
E-Mail: [email protected] www.electrocraft.com May 2009
3
1. Safety & Installation
The SCA-SE-30-06 requires installation by qualified personal which must pay
attention to significant safety and other regulatory standards. They should be
thoroughly familiar with the entire system before beginning installation.
Before final operation of machine be sure to test hookup with motor but
disconnected from the load. Improper wiring could cause a “motor run away”
condition, and cause serious injury or damage to the machine and persona
Before starting installation of the SCA-SE-30-06, be sure that main power is
disconnected. After powering the drive it should not be touched by hand or
risk shock.
European directive EN 61800-3 (1996).
nterference with other devices. Damaged items have to be
sitive Device (ESD). Electrostatic
discharge needs to be avoided.
Certain applications may involve special requirements. Consult Factory!
Take care that in case of regeneration or in brake operation the energy
recovery must be buffered by the power supply and / or a braking module.
Ensure with electronically stabilized power supplies that protection circuit isn’t
react.
Don’t switch off the power supply while the motor is turning, in this case the
drive could be destroyed by regeneration.
We recommend connecting a capacitor of 1000 µF per each ampere output
current close to power input, in parallel.
Do not repair or open drives enclosure. Result would result in personal injury
and would void all warranties.
The SCA-SE-30-06 comply with the
The followings points must followed:
•
A metal mounting plate with correct grounding is mandatory.
•
For installation purposes, tooth lock washers have to be used.
•
For most wiring schemes, only shielded cables are admissible, to
suppress i
replaced.
•
Provide for a large contact area between shields and mounting plate.
•
The motor has to be grounded in the prescribed manner.
•
The drive is an Electrostatic Sen
NOTE:
