U.S.A. and Canada only. For customer orders, contact Customer Service at:
800/392-3497 Fax: 800/955-6831
Europe, Africa, and Middle East only. For customer orders, contact Customer Service at:
+ 49 9421-706 0 Fax: + 49 9421-706 265
Other International locations. For customer orders, contact Customer Service at:
+ 1 952 884-4051 Fax: + 1 952 736-4212
For warranty repair or service information, contact the Service Repair department at:
800/685-2606
For technical assistance, contact Technical Support at:
866/78AUDIO
Specifications subject to change without notice.
12000 Portland Avenue South, Burnsville, MN 55337
Phone: 952/884-4051, Fax: 952/884-0043
www.electrovoice.com
© Telex Communications, Inc. 9/2005
Part Number 38110-471 Rev. A
Dimension Drawings:
SL8.2 Part Number
• 301853-003 - SL8.2, 100° x 100° Horn, Black Finish
Performance Match
• D170261
CPS2.8, 120V Power Amplifier, 2 x 800W
Accessories
• 301918-001
AB-ZX1i, Array Bracket Kit for 2 or 4 Systems,
Black
• 301955-001
TC-ZX1i, Terminal Cover with Gland Nut
Front View
Top View
Right View
This SL8.2 Loudspeaker should be suspended overhead
only in accordance with the procedures and limitations
specified in the
ZX1 Users Manual
and possible manual
update notices. This system should be suspended with
certified rigging hardware by an authorized rigging profes-
sional and in compliance with local, state, and federal
overhead suspension ordinances.
CAUTION
Architectural and Engineering Specs:
The loudspeaker shall be a two-way system consisting of one 8"” (102mm) low-
frequency transducer, 1.25" titanium diaphragm true high-frequency compression
driver, and frequency dividing network installed in a vented enclosure. The network
shall include a full-range passive limiter for protection of both the low frequency and
high frequency transducers. The high frequency compression transducer shall drive
a horn to evenly cover a pattern of 100° by 100°. The enclosure shall be molded of
high impact polystyrene.
The finish shall be a paintable black. The grille shall be zinc plated, powder coated for
corrosion resistance, and equipped with both hydrophobic cloth and acoustic foam.
The loudspeaker position shall be adjustable over a range of 100° horizontally and 35°
vertically.
The support bracket shall be low profile and integral with the enclosure. The bracket
shall allow for a quick snap fit mounting of the speaker enclosure for placement
before securing. The speaker terminals shall include a 4 pin removable phoenix style
connector to allow for signal pass through. The system shall be weather resistant to
MIL Spec 810 and IEC 529 test conditions.
The loudspeaker system shall meet the following performance criteria: Power handling,
200-Watts long term program using IEC268-5 shaped pink noise; Frequency response,
48 Hz – 20 kHz (-10 dB from rated sensitivity); Pressure sensitivity, 92 dB at one
watt, 60 Hz – 20 kHz at one meter; Impedance, 8 ohms nominal, 6 ohms minimum.
The enclosure shall be 17.75" (451mm) high, 11.12" (282mm) wide, 10.35" (263mm)
deep. Net weight shall be 18.5 lbs (8.4 kg).
